MX240 Ethernet Services Router Hardware Guide
Installing an SFP or XFP Transceiver
To install an SFP or XFP:
1.Attach an ESD wrist strap to your bare wrist and connect the wrist strap to one of the ESD points on the chassis.
2.Take each transceiver to be installed out of its electrostatic bag and identify the slot on the DPC where it will be installed.
3.Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the transceiver with a safety cap.
4.Carefully align the transceiver with the slots in the DPC. The connectors should face the DPC.
5.Slide the transceiver until the connector is seated in the DPC slot. If you are unable to fully insert the transceiver, make sure the connector is facing the right way.
6.Close the ejector handle of the transceiver.
7.Remove the rubber safety cap from the transceiver and the end of the cable. Insert the cable into the transceiver.
8.Verify that the status LEDs on the DPC faceplate indicate that the SFP or XFP is functioning correctly. For more information about the DPC LEDs, see the
Replacing Power System Components
Redundant power supplies (AC or DC) are
NOTE: The minimum number of power supplies must be present in the router at all times.
NOTE: To maintain proper cooling and prevent thermal shutdown of the operating power supply unit, each power supply slot must contain either a power supply or a blank panel. If you remove a power supply, you must install a replacement power supply or a blank panel shortly after the removal.
To replace a power system component, use the following procedures:
■Removing an AC Power Supply on page 113
■Installing an AC Power Supply on page 114
■Removing a DC Power Supply on page 114
■Installing a DC Power Supply on page 116
112■ Replacing Power System Components