Magnum 6K8-Series Industrial Field Switch Installation and User Guide 03/06)
(MDIX) features to eliminate the use of cross-over cables. The two fiber ports operate at 100Mbps full-duplex (default). User mode control per port through the MNS software is also the same.
On Magnum “4+2” Combo modules, there are four LED’s for each RJ-45 port, which indicate status as described for the 6K8-RJ45 in Section 2.2.3 above. The fiber port LEDs indicate status the same way as described for the SFF fiber modules in Section
2.2.2above. Color-coding on the panel of the module shows which LEDs belong to which port.
| 10/100 | 1 | 3 | | | 5 | | | 7 | | LK | The Magnum Combo six- |
| | | | | | | | | | | | | | | | port modules are also available with |
| | | | | | | | | | | | | | | |
| | | | | | | | | | | | | | | | | | |
| F/H | | | | | | | | | | | | | | | | ACT | 4@ MTRJ 100Mb mm SFF fiber and |
| | | | | | | | | | | | | | | |
| | | | | | | | | | | | | | | |
| | ACT | | | | | | | ACT | | | | | | | 2@10Mb fiber mm ST ports, or 4@ |
| | | | | | | | | | | | |
| | F/H | | | | | | | | F/H | | | | | | |
| | | 2 | | | | | 6 | | | | | | RJ45 10/100 copper and 2@10Mb |
| | | TX | LK RX | | | TX | LK | RX |
| | | | | | | | | | | | | | | | | | | fiber mm ST ports. The |
4@ RJ-45 + 2@ 10 Mb ST | | operation of the SFF fiber and the RJ-45 half of |
the module is as described for those port types above. For detailed information about 10Mb mm ST fiber half of the module, see Section 2.2.5.
2.2.5Four-Port 10 Mb and 100Mb mm Fiber ST Modules
ACT
F/H
1TX LK RX
ACT
F/H
5TX LK RX
ACT | | | ACT | | | |
F/H | | | F/H | T | LK | R |
2 | TX | LK RX | 6 |
The 4-port @10Mb ST fiber modules behave the same as the 4@100Mb ST fiber modules except for the 10Mb speed. For port numbering, ports 1, 2, 5, 6 are present, ports 3, 4. 7, 8 are not present. There is also a similar 100Mb fiber SC module.
The default setup on the 10Mb fiber module is half-duplex, which allows the Magnum 6K8-Series Switch to connect to any 10Mb hub or media converter or almost any other device with a 10Mb fiber Ethernet port. The default setting of the 100Mb fiber module is full duplex. User mode-control per port through the MNS “port settings” software is the same as the other 6K8-Series modules.
The fiber ports support fiber-cabling distances according to the 10BASE-FL and 100BASE-FX standards, i.e., 2km distance for multi-mode fiber. (Single-mode for up to greater distance may be available as a special order, request quote).
www . GarrettCom . com