Magnum 6K8-Series Industrial Field Switch | Installation and User Guide 03/06) |
4.2Dual LEDs Status on TOP and Front of the 6K8-Series unit
PWR/POWER : Power LED, ON when external power is applied to the unit.
LK/LINK : Steady ON, Link status for 10 Mbps and 100Mbps operation.
ACT | : ON with port activity for 10 Mbps and 100Mbps operation. |
F/H | : Full / Half duplex LED, ON when the port is running full duplex, |
| OFF for half duplex. |
10/100 | : Speed LED, ON when the speed is 100Mbps, OFF when the |
| speed is 10 Mbps |
4.3Auto-Cross(MDIX) and Auto-negotiation, for RJ-45 ports
The RJ-45 ports independently support auto-cross (MDI or MDIX) in auto-negotiation mode and will work properly with all the other connected devices with RJ-45 port whether it supports Auto-negotiation or not (e.g 10Mb Hub, media converter) or fixed mode at 10Mb or 100Mb Half/Full Duplex(managed switch). No cross-over cable is required while using the 6K8’s copper port to other devices. Operation is according to the IEEE 802.3u standard.
The Managed 6K8-Series Fast Ethernet copper ports, can be set for either fixed 100Mb speed or for 10/100 F/H N-way auto-negotiation per the IEEE802.3u standard. The selection is made via MNS software. The factory default setting is for auto-negotiation. At 10Mb or 100Mb-fixed speed, the user may select half- or full-duplex mode by MNS Software for each RJ-45 port separately. For detail information See Section (10.1 at
page no.52) of this manual to access the “6K-MNS(Rel 3) Software user guide”
One frequently-used application for the Managed Magnum 6K8-Series Switch copper ports is to connect one of them using a fiber media converter to another Switch in the network backbone, or to some other remote 100Mb device. In this case, it is desirable to operate the fiber link at 100Mb speed, and at either half- or full duplex mode
www . GarrettCom . com