EverFocus ESM316T002R user manual Port Setting

Page 11

Figure 8: Port Setting

Hint§

The following parameters are displayed on the Port Setting configuration:

■Port—Set up one or more ports. Hold down the CTRL key and click port numbers to select multiple ports. Hold down the SHIFT key to select a range of ports.

■State—Set the link state of port interfaces. (Default: Enabled)

■Speed/Duplex—Configure the port speed and duplex mode using auto-negotiation or manual selection. (Default: Auto-negotiation enabled)

■Auto - Enable auto-negotiation. When using auto-negotiation, the optimal settings will be negotiated between the link partners based on their advertised capabilities. Auto must be enabled for all 1 Gbps connections.

■100M/Full - Support 100 Mbps full-duplex operation

■100M/Half - Support 100 Mbps half-duplex operation

■10M/Full - Support 10 Mbps full-duplex operation

■10M/Half - Support 10 Mbps half-duplex operation

■Flow Control—Display the following:

■Config – The configured flow control mode of the port.

■Actual – Indicate the link status of the port. When a link is up, indicates the operating flow control mode.

11

Image 11

Contents Gigabit Managed Ethernet Switch 16 PoE+ Ports Content Monitoring About this Guide Web Browser IntroductionLogging Login Popping Up WindowWeb-Based Management Interface System Information IP Address SettingHint§ IPv6 Address SettingUser Account Port SettingPort Setting Trunk Group Setting ConfigurationTrunk Distribution Algorithm Setting Trunk Distribution Algorithm SettingPage Lacp Setting Lacp SettingStatic Vlan Table Setting Static Vlan Table SettingVlan Port Setting Vlan Port SettingVLAN-Stacking Table Setting VLAN-Stacking Table SettingVlan Stacking Setting Vlan Stacking SettingHint§ Multicast Entry Table Igmp Multicast Group InformationIgmp Snooping Igmp SnoopingIgmp Global Setting Hint§ Igmp Vlan SettingSpanning Tree Spanning tree settingsPage Spanning tree port settings Spanning Tree Port SettingPage Port-based Priority Setting Quality of Service QoSDSCP-based Priority Setting DSCP-based Priority SettingPriority to Queue Mapping Setting Priority to Queue Mapping SettingPacket Scheduling Setting Packet Scheduling SettingLldp Settings Lldp ConfigurationsLldp Neighbors Lldp NeighborsSnmp Setting Trap Receivers Setting Port mirroring Port Mirroring SettingPort security Port Security SettingPage Bandwidth control Bandwidth Control SettingPage Jumbo Frame Setting Jumbo Frame SettingManagement Access Filter Management Access FilterPower over Ethernet Power over Ethernet SettingMAC Address Information SecurityStatic MAC Setting Static MAC SettingMAC Filtering Setting 802.1x Setting 802.1x Setting802.1x Port Setting 802.1x Port SettingIP Filter Configurations IP Filter ConfigurationsPage Storm Control settings Storm Control settingsPort Isolation Port IsolationDefence Engine Defence EnginePort Statistics Information MonitoringHttp Upgrade Http UpgradeReset Reset Factory DefaultsSpecifications Reboot