EverFocus ESM316T002R user manual DSCP-based Priority Setting

Page 30

DSCP-based Priority Setting

The Differentiated Services Code Point (DSCP) is a six-bit field in the IP header, allowing coding for up to 64 different forwarding behaviors. The DSCP replaces the ToS bits, but it retains backward compatibility with the three precedence bits so that non-DSCP compliant, ToS-enabled devices, will not conflict with the DSCP mapping. Based on network policies, different kinds of traffic can be marked for different kinds of forwarding. Note that all the DSCP values that are not specified are mapped to priority value 0.

Web Smart switch interface

To configure port-level DSCP remarking,

1.Click Configuration, QoS, DSCP-based Priority.

2.Map one or more DSCP values to a priority value.

3.Click Apply.

Figure 21: DSCP-based Priority Setting

Hint§

The following parameters are shown on the DSCP-based Priority Setting page:

DSCP - List the DSCP values. (Range: 0-63)

Priority — Map a priority value to the selected DSCP Priority value. Note that “0” represents low priority and “7” represent high priority.

DSCP Priority Table — Show the DSCP to Priority map.

30

Image 30
Contents Gigabit Managed Ethernet Switch 16 PoE+ Ports Content Monitoring About this Guide Introduction Web BrowserLogin Popping Up Window LoggingWeb-Based Management Interface IP Address Setting System InformationIPv6 Address Setting Hint§Port Setting User AccountPort Setting Configuration Trunk Group SettingTrunk Distribution Algorithm Setting Trunk Distribution Algorithm SettingPage Lacp Setting Lacp SettingStatic Vlan Table Setting Static Vlan Table SettingVlan Port Setting Vlan Port SettingVLAN-Stacking Table Setting VLAN-Stacking Table SettingVlan Stacking Setting Vlan Stacking SettingHint§ Igmp Multicast Group Information Multicast Entry TableIgmp Snooping Igmp SnoopingIgmp Global Setting Igmp Vlan Setting Hint§Spanning tree settings Spanning TreePage Spanning Tree Port Setting Spanning tree port settingsPage Quality of Service QoS Port-based Priority SettingDSCP-based Priority Setting DSCP-based Priority SettingPriority to Queue Mapping Setting Priority to Queue Mapping SettingPacket Scheduling Setting Packet Scheduling SettingLldp Configurations Lldp SettingsLldp Neighbors Lldp NeighborsSnmp Setting Trap Receivers Setting Port Mirroring Setting Port mirroringPort Security Setting Port securityPage Bandwidth Control Setting Bandwidth controlPage Jumbo Frame Setting Jumbo Frame SettingManagement Access Filter Management Access FilterPower over Ethernet Setting Power over EthernetSecurity MAC Address InformationStatic MAC Setting Static MAC SettingMAC Filtering Setting 802.1x Setting 802.1x Setting802.1x Port Setting 802.1x Port SettingIP Filter Configurations IP Filter ConfigurationsPage Storm Control settings Storm Control settingsPort Isolation Port IsolationDefence Engine Defence EngineMonitoring Port Statistics InformationHttp Upgrade Http UpgradeReset Factory Defaults ResetReboot Specifications