EverFocus ESM316T002R user manual 802.1x Setting

Page 48

802.1x Setting

The 802.1X protocol provides port authentication. The 802.1X protocol must be enabled globally for the switch system before port settings are active.

Web Smart switch interface

To configure 802.1X global settings:

1.Click Security, 802.1X, 802.1X Setting.

2.Set 802.1X to Enabled.

3.Specify the RADIUS server IP address.

4.Specify the RADIUS server shared key.

5.Modified other parameters as required.

6.Click Apply.

Figure 36: 802.1x Setting

Hint§

The following parameters are shown on the LLDP Neighbors page. ■802.1X — Sets the global setting for 802.1X. (Default: Disabled) ■RADIUS Server IP — Address of the authentication server.

■Server Port — Network (UDP) port of RADIUS server used for authentication messages. (Range: 1024-65535;

Default: 1812)

■Shared Key — Encryption key used for RADIUS server messages. Do not use blank spaces in the string. (Maximum length: 30 characters)

■Retype Shared Key — Re-type the string entered in the previous field to ensure no errors were made. The switch will not change the encryption key if these two fields do not match.

■ReauthEnabled — Set clients to be re-authenticated after the interval specified by the Reauth Period. Re-authentication can be used to detect if a new device is plugged into a switch port. (Default: Enabled) ■Reauth Period — Set the time period after which a connected client must be re-authenticated. (Range:

30-65535 seconds; Default: 3600 seconds)

48

Image 48

Contents Gigabit Managed Ethernet Switch 16 PoE+ Ports Content Monitoring About this Guide Introduction Web BrowserLogin Popping Up Window LoggingWeb-Based Management Interface IP Address Setting System InformationIPv6 Address Setting Hint§Port Setting User AccountPort Setting Configuration Trunk Group SettingTrunk Distribution Algorithm Setting Trunk Distribution Algorithm SettingPage Lacp Setting Lacp SettingStatic Vlan Table Setting Static Vlan Table SettingVlan Port Setting Vlan Port SettingVLAN-Stacking Table Setting VLAN-Stacking Table SettingVlan Stacking Setting Vlan Stacking SettingHint§ Igmp Multicast Group Information Multicast Entry TableIgmp Snooping Igmp SnoopingIgmp Global Setting Igmp Vlan Setting Hint§Spanning tree settings Spanning TreePage Spanning Tree Port Setting Spanning tree port settingsPage Quality of Service QoS Port-based Priority SettingDSCP-based Priority Setting DSCP-based Priority SettingPriority to Queue Mapping Setting Priority to Queue Mapping SettingPacket Scheduling Setting Packet Scheduling SettingLldp Configurations Lldp SettingsLldp Neighbors Lldp NeighborsSnmp Setting Trap Receivers Setting Port Mirroring Setting Port mirroringPort Security Setting Port securityPage Bandwidth Control Setting Bandwidth controlPage Jumbo Frame Setting Jumbo Frame SettingManagement Access Filter Management Access FilterPower over Ethernet Setting Power over EthernetSecurity MAC Address InformationStatic MAC Setting Static MAC SettingMAC Filtering Setting 802.1x Setting 802.1x Setting802.1x Port Setting 802.1x Port SettingIP Filter Configurations IP Filter ConfigurationsPage Storm Control settings Storm Control settingsPort Isolation Port IsolationDefence Engine Defence EngineMonitoring Port Statistics InformationHttp Upgrade Http UpgradeReset Factory Defaults ResetReboot Specifications