EverFocus ESM316T002R user manual Packet Scheduling Setting

Page 32

Packet Scheduling Setting

You can set the switch to service the queues based on a strict rule that requires all traffic in a higher priority queue to be processed before lower priority queues are serviced, Weighted Fair Queuing (WFQ), or Weighted Round-Robin (WRR) queuing that specifies a relative weight of each queue. The traffic classes are mapped to one of the eight egress queues provided for each port. You can assign a weight to each of these queues (and thereby to the corresponding traffic priorities). This weight sets the frequency at which each queue will be polled for service, and subsequently affects the response time for software applications assigned a specific priority value.

Web Smart switch interface

To configure port-level DSCP remarking,

1.Click Configuration, QoS, Packet Scheduling.

2.Select the scheduling algorithm, WFQ or WRR.

3.Map scheduling weights to a queue ID, or select “Strict.”

4.Click Apply.

Figure 23: Packet Scheduling Setting

Hint§

The following parameters are shown on the DSCP-based Priority Setting page:

■Scheduling Algorithm - Select the service method used for port egress queues.

■Weight-fair-queue - Service the egress queues containing data based on the weight of the queue compared

32

Image 32

Contents Gigabit Managed Ethernet Switch 16 PoE+ Ports Content Monitoring About this Guide Introduction Web BrowserLogin Popping Up Window LoggingWeb-Based Management Interface IP Address Setting System InformationIPv6 Address Setting Hint§Port Setting User AccountPort Setting Configuration Trunk Group SettingTrunk Distribution Algorithm Setting Trunk Distribution Algorithm SettingPage Lacp Setting Lacp SettingStatic Vlan Table Setting Static Vlan Table SettingVlan Port Setting Vlan Port SettingVLAN-Stacking Table Setting VLAN-Stacking Table SettingVlan Stacking Setting Vlan Stacking SettingHint§ Igmp Multicast Group Information Multicast Entry TableIgmp Snooping Igmp SnoopingIgmp Global Setting Igmp Vlan Setting Hint§Spanning tree settings Spanning TreePage Spanning Tree Port Setting Spanning tree port settingsPage Quality of Service QoS Port-based Priority SettingDSCP-based Priority Setting DSCP-based Priority SettingPriority to Queue Mapping Setting Priority to Queue Mapping SettingPacket Scheduling Setting Packet Scheduling SettingLldp Configurations Lldp SettingsLldp Neighbors Lldp NeighborsSnmp Setting Trap Receivers Setting Port Mirroring Setting Port mirroringPort Security Setting Port securityPage Bandwidth Control Setting Bandwidth controlPage Jumbo Frame Setting Jumbo Frame SettingManagement Access Filter Management Access FilterPower over Ethernet Setting Power over EthernetSecurity MAC Address InformationStatic MAC Setting Static MAC SettingMAC Filtering Setting 802.1x Setting 802.1x Setting802.1x Port Setting 802.1x Port SettingIP Filter Configurations IP Filter ConfigurationsPage Storm Control settings Storm Control settingsPort Isolation Port IsolationDefence Engine Defence EngineMonitoring Port Statistics InformationHttp Upgrade Http UpgradeReset Factory Defaults ResetReboot Specifications