EverFocus ESM316T002R user manual Lldp Configurations, Lldp Settings

Page 33

to the sum of the weights of all queues. (This is the default selection.)

■Weight-round-robin - Share bandwidth at the egress ports by using the scheduling weights for queues 1 through 8 respectively. WRR specifies a relative weight for each queue that determines the percentage of service time the switch services each queue before moving on to the next queue.

■Queue ID - Output queue buffer. (Range: 1-8, where 8 is the highest priority queue)

■Weight - Set a new weight for the selected traffic class. (Range: Strict or 1-15)

Use queue weights 1-15 for queues to allocate service time based on WFQ or WRR. Queue weights must be configured in ascendant manner, assigning more weight to each higher numbered queue.

Strict priority requires all traffic in the queue to be processed before lower priority queues are serviced.

LLDP Configurations

LLDP is a Layer 2 protocol that uses periodic broadcasts to advertise information about the sending device.

Web Smart switch interface

To configure global and port settings for LLDP:

1.Click Configuration, LLDP, LLDP Settings.

2.Enable LLDP for the switch.

3.If required, modified other LLDP parameters.

4.For one or a group of ports, set the LLDP mode.

5.Click Apply.

Figure 24: LLDP Settings

Hint§

The following parameters are shown on the LLDP Settings.

33

Image 33

Contents Gigabit Managed Ethernet Switch 16 PoE+ Ports Content Monitoring About this Guide Web Browser IntroductionLogging Login Popping Up WindowWeb-Based Management Interface System Information IP Address SettingHint§ IPv6 Address SettingUser Account Port SettingPort Setting Trunk Group Setting ConfigurationTrunk Distribution Algorithm Setting Trunk Distribution Algorithm SettingPage Lacp Setting Lacp SettingStatic Vlan Table Setting Static Vlan Table SettingVlan Port Setting Vlan Port SettingVLAN-Stacking Table Setting VLAN-Stacking Table SettingVlan Stacking Setting Vlan Stacking SettingHint§ Multicast Entry Table Igmp Multicast Group InformationIgmp Snooping Igmp SnoopingIgmp Global Setting Hint§ Igmp Vlan SettingSpanning Tree Spanning tree settingsPage Spanning tree port settings Spanning Tree Port SettingPage Port-based Priority Setting Quality of Service QoSDSCP-based Priority Setting DSCP-based Priority SettingPriority to Queue Mapping Setting Priority to Queue Mapping SettingPacket Scheduling Setting Packet Scheduling SettingLldp Settings Lldp ConfigurationsLldp Neighbors Lldp NeighborsSnmp Setting Trap Receivers Setting Port mirroring Port Mirroring SettingPort security Port Security SettingPage Bandwidth control Bandwidth Control SettingPage Jumbo Frame Setting Jumbo Frame SettingManagement Access Filter Management Access FilterPower over Ethernet Power over Ethernet SettingMAC Address Information SecurityStatic MAC Setting Static MAC SettingMAC Filtering Setting 802.1x Setting 802.1x Setting802.1x Port Setting 802.1x Port SettingIP Filter Configurations IP Filter ConfigurationsPage Storm Control settings Storm Control settingsPort Isolation Port IsolationDefence Engine Defence EnginePort Statistics Information MonitoringHttp Upgrade Http UpgradeReset Reset Factory DefaultsSpecifications Reboot