EverFocus ESM316T002R user manual Trap Receivers Setting

Page 36

Hint§

The following parameters are shown on the SNMP Setting, Community Strings Setting.

■SNMP Status - Enable or disable SNMP service. (Default: Disabled)

■System Name - A name assigned to the switch system.

■System Location - Specify the system location.

■System Contact - An administrator responsible for the system.

■String – A community string that acts like a password and permits access to the SNMP protocol.

Default strings: “public” (read-only access), “private” (read-write access) Range: 1-32 characters, case sensitive

■Type - Specifies the access rights for the community string:

■Read-Only - Authorized management stations are only able to retrieve MIB objects.

■Read-Write - Authorized management stations are able to both retrieve and modify MIB objects.

Trap Receivers Setting

Traps indicating status changes are issued by the switch to specified trap managers. You must specify trap managers so that key events are reported by this switch to your management station (using network management software).

Web Smart switch interface

To configure SNMP system settings:

1.Click Configuration, SNMP Setting.

2.Specify the IP address of management station that will receive SNMP trap messages.

3.Specify a configured community string for the trap receiver.

4.Click Apply.

Hint§

The following parameters are shown on the Trap Receivers Setting.

■IP Address - IP address of a new management station to receive notification messages.

■Community String – Specify a valid community string for the new trap manager entry. The string must already be defined in the Community String Setting section. (Range: 1-32 characters, case sensitive)

36

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Gigabit Managed Ethernet Switch 16 PoE+ Ports Content Monitoring About this Guide Introduction Web BrowserLogin Popping Up Window LoggingWeb-Based Management Interface IP Address Setting System InformationIPv6 Address Setting Hint§Port Setting User AccountPort Setting Configuration Trunk Group SettingTrunk Distribution Algorithm Setting Trunk Distribution Algorithm SettingPage Lacp Setting Lacp SettingStatic Vlan Table Setting Static Vlan Table SettingVlan Port Setting Vlan Port SettingVLAN-Stacking Table Setting VLAN-Stacking Table SettingVlan Stacking Setting Vlan Stacking SettingHint§ Igmp Multicast Group Information Multicast Entry TableIgmp Snooping Igmp SnoopingIgmp Global Setting Igmp Vlan Setting Hint§Spanning tree settings Spanning TreePage Spanning Tree Port Setting Spanning tree port settingsPage Quality of Service QoS Port-based Priority SettingDSCP-based Priority Setting DSCP-based Priority SettingPriority to Queue Mapping Setting Priority to Queue Mapping SettingPacket Scheduling Setting Packet Scheduling SettingLldp Configurations Lldp SettingsLldp Neighbors Lldp NeighborsSnmp Setting Trap Receivers Setting Port Mirroring Setting Port mirroringPort Security Setting Port securityPage Bandwidth Control Setting Bandwidth controlPage Jumbo Frame Setting Jumbo Frame SettingManagement Access Filter Management Access FilterPower over Ethernet Setting Power over EthernetSecurity MAC Address InformationStatic MAC Setting Static MAC SettingMAC Filtering Setting 802.1x Setting 802.1x Setting802.1x Port Setting 802.1x Port SettingIP Filter Configurations IP Filter ConfigurationsPage Storm Control settings Storm Control settingsPort Isolation Port IsolationDefence Engine Defence EngineMonitoring Port Statistics InformationHttp Upgrade Http UpgradeReset Factory Defaults ResetReboot Specifications
Top Page Image Contents