EverFocus ESM316T002R user manual Power over Ethernet Setting

Page 44

Power over Ethernet Setting

Power over Ethernet (PoE) means that power sourcing equipment (PSE) supplies power to powered devices (PD) such as IP telephone, wireless LAN access point, and web camera from Ethernet interfaces through twisted pair cables.

Web Smart switch interface

1.Click Configuration, Power over Ethernet.

2.Select the port number of the connected PD.

3.Specify the PD on.

4.Click Apply.

Figure 32: Power over Ethernet

Hint§

The following parameters are shown on the Power over Ethernet page.

PD - Enable the powered devices. The consumption power in watt will be shown in the table below. Class – Indicate the PD classification.

Consumption Power (W) – Indicate the PD power consumption.

Once the PSE has detected the PD’s power class, the PSE can manage the power allocation by subtracting the PD’s class maximum value from overall power budget. This allows for control and management of power allocation when there is not enough power available from the PSE to supply maximum power to all ports.

44

Image 44
Contents Gigabit Managed Ethernet Switch 16 PoE+ Ports Content Monitoring About this Guide Introduction Web BrowserLogin Popping Up Window LoggingWeb-Based Management Interface IP Address Setting System InformationIPv6 Address Setting Hint§Port Setting User AccountPort Setting Configuration Trunk Group SettingTrunk Distribution Algorithm Setting Trunk Distribution Algorithm SettingPage Lacp Setting Lacp SettingStatic Vlan Table Setting Static Vlan Table SettingVlan Port Setting Vlan Port SettingVLAN-Stacking Table Setting VLAN-Stacking Table SettingVlan Stacking Setting Vlan Stacking SettingHint§ Igmp Multicast Group Information Multicast Entry TableIgmp Snooping Igmp SnoopingIgmp Global Setting Igmp Vlan Setting Hint§Spanning tree settings Spanning TreePage Spanning Tree Port Setting Spanning tree port settingsPage Quality of Service QoS Port-based Priority SettingDSCP-based Priority Setting DSCP-based Priority SettingPriority to Queue Mapping Setting Priority to Queue Mapping SettingPacket Scheduling Setting Packet Scheduling SettingLldp Configurations Lldp SettingsLldp Neighbors Lldp NeighborsSnmp Setting Trap Receivers Setting Port Mirroring Setting Port mirroringPort Security Setting Port securityPage Bandwidth Control Setting Bandwidth controlPage Jumbo Frame Setting Jumbo Frame SettingManagement Access Filter Management Access FilterPower over Ethernet Setting Power over EthernetSecurity MAC Address InformationStatic MAC Setting Static MAC SettingMAC Filtering Setting 802.1x Setting 802.1x Setting802.1x Port Setting 802.1x Port SettingIP Filter Configurations IP Filter ConfigurationsPage Storm Control settings Storm Control settingsPort Isolation Port IsolationDefence Engine Defence EngineMonitoring Port Statistics InformationHttp Upgrade Http UpgradeReset Factory Defaults ResetReboot Specifications