EverFocus ESM316T002R user manual Lacp Setting

Page 15

LACP Setting

The LACP (link aggregation control protocol) dynamically aggregates ports and removes aggregations. LACP interacts with its peer by sending LACPDUs (link aggregation control protocol data units).

Web Smart switch interface

To arrange LACP settings,

1.Click Configuration, Link Aggregation, LACP Setting.

2.Enable LACP on the switch.

3.Specify the LACP System Priority to identify LAGs (link aggregation group) on the switch.

4.Click Apply.

Figure 11: LACP Setting

Hint§

The following parameters are shown on the LACP Setting:

■LACP Status – Specify whether LACP is enabled on this switch. LACP will aggregate two or more ports if they belong to the same group. LACP can form up to 8 trunks per switch.

■System Priority – LACP system priority is used to identify LAGs membership of this switch to other switches during LAG negotiations. (Range: 0-65535, Default: 32768)

15

Image 15

Contents Gigabit Managed Ethernet Switch 16 PoE+ Ports Content Monitoring About this Guide Web Browser IntroductionLogging Login Popping Up WindowWeb-Based Management Interface System Information IP Address SettingHint§ IPv6 Address SettingUser Account Port SettingPort Setting Trunk Group Setting ConfigurationTrunk Distribution Algorithm Setting Trunk Distribution Algorithm SettingPage Lacp Setting Lacp SettingStatic Vlan Table Setting Static Vlan Table SettingVlan Port Setting Vlan Port SettingVLAN-Stacking Table Setting VLAN-Stacking Table SettingVlan Stacking Setting Vlan Stacking SettingHint§ Multicast Entry Table Igmp Multicast Group InformationIgmp Snooping Igmp SnoopingIgmp Global Setting Hint§ Igmp Vlan SettingSpanning Tree Spanning tree settingsPage Spanning tree port settings Spanning Tree Port SettingPage Port-based Priority Setting Quality of Service QoSDSCP-based Priority Setting DSCP-based Priority SettingPriority to Queue Mapping Setting Priority to Queue Mapping SettingPacket Scheduling Setting Packet Scheduling SettingLldp Settings Lldp ConfigurationsLldp Neighbors Lldp NeighborsSnmp Setting Trap Receivers Setting Port mirroring Port Mirroring SettingPort security Port Security SettingPage Bandwidth control Bandwidth Control SettingPage Jumbo Frame Setting Jumbo Frame SettingManagement Access Filter Management Access FilterPower over Ethernet Power over Ethernet SettingMAC Address Information SecurityStatic MAC Setting Static MAC SettingMAC Filtering Setting 802.1x Setting 802.1x Setting802.1x Port Setting 802.1x Port SettingIP Filter Configurations IP Filter ConfigurationsPage Storm Control settings Storm Control settingsPort Isolation Port IsolationDefence Engine Defence EnginePort Statistics Information MonitoringHttp Upgrade Http UpgradeReset Reset Factory DefaultsSpecifications Reboot