EverFocus ESM316T002R user manual Monitoring, Port Statistics Information

Page 55

CHAPTER 5 Monitoring

Port Statistics Information

You can display standard statistics on network traffic passing through each port. This information can be used to identify potential problems with the switch, such as a faulty port or unusually heavy loading. All values displayed have been accumulated since the last system reboot.

Web Smart switch interface

To click Monitoring, Port Statistics to display port statistics.

Figure 42: Port Statistics Information

Hint§

The following parameters are shown on the Port Statistics Information page.

Port - The port number.

State - Display the link state of port interfaces (Enabled or Disabled).

Link Status - Display the link state of the port interface (Link Up or Link Down).

TxGoodPkt - The total number of packets transmitted out of the interface.

TxBadPkt - The total number of outbound packets that could not be transmitted because of errors.

RxGoodPkt - The total number of packets received on the interface.

RxBadPkt - The total number of inbound packets that contained errors preventing them from being deliverable.

Clear - Click the button to reset all counters.

55

Image 55
Contents Gigabit Managed Ethernet Switch 16 PoE+ Ports Content Monitoring About this Guide Web Browser IntroductionLogging Login Popping Up WindowWeb-Based Management Interface System Information IP Address SettingHint§ IPv6 Address SettingUser Account Port SettingPort Setting Trunk Group Setting ConfigurationTrunk Distribution Algorithm Setting Trunk Distribution Algorithm SettingPage Lacp Setting Lacp SettingStatic Vlan Table Setting Static Vlan Table SettingVlan Port Setting Vlan Port SettingVLAN-Stacking Table Setting VLAN-Stacking Table SettingVlan Stacking Setting Vlan Stacking SettingHint§ Multicast Entry Table Igmp Multicast Group InformationIgmp Snooping Igmp SnoopingIgmp Global Setting Hint§ Igmp Vlan SettingSpanning Tree Spanning tree settingsPage Spanning tree port settings Spanning Tree Port SettingPage Port-based Priority Setting Quality of Service QoSDSCP-based Priority Setting DSCP-based Priority SettingPriority to Queue Mapping Setting Priority to Queue Mapping SettingPacket Scheduling Setting Packet Scheduling SettingLldp Settings Lldp ConfigurationsLldp Neighbors Lldp NeighborsSnmp Setting Trap Receivers Setting Port mirroring Port Mirroring SettingPort security Port Security SettingPage Bandwidth control Bandwidth Control SettingPage Jumbo Frame Setting Jumbo Frame SettingManagement Access Filter Management Access FilterPower over Ethernet Power over Ethernet SettingMAC Address Information SecurityStatic MAC Setting Static MAC SettingMAC Filtering Setting 802.1x Setting 802.1x Setting802.1x Port Setting 802.1x Port SettingIP Filter Configurations IP Filter ConfigurationsPage Storm Control settings Storm Control settingsPort Isolation Port IsolationDefence Engine Defence EnginePort Statistics Information MonitoringHttp Upgrade Http UpgradeReset Reset Factory DefaultsSpecifications Reboot