Installing the DC Power Supply
2.Remove the vent plate covering all power supply slots by loosening the top and bottom captive screws, as shown in Figure 1‐3.
Note: The vent plate cannot be replaced over DC power supplies. Enterasys Networks recommends that you store the vent plate in a safe location in case of future reuse.
Figure 1-3 Removing Power Supply Vent Plate
1 | Power supply slot (PS1) | 3 | Vent plate |
2 | Power supply coverplate | 4 | Captive screws (2) |
3.Locate the PS1 power supply slot, as shown in Figure 1‐3.
4.Ensure that the breaker switch on the DC power supply is set to Off.
Matrix X Router DC Power Supply Installation Guide