Enterasys Networks CM Version 1.0 manual

Page 3

Electrical Hazard: Only qualified personnel should perform installation procedures.

Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes Personal vorgenommen werden.

Notice

Enterasys Networks reserves the right to make changes in specifications and other information contained in this document and its web site without prior notice. The reader should in all cases consult Enterasys Networks to determine whether any such changes have been made.

The hardware, firmware, or software described in this document is subject to change without notice.

IN NO EVENT SHALL ENTERASYS NETWORKS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS DOCUMENT, WEB SITE, OR THE INFORMATION CONTAINED IN THEM, EVEN IF ENTERASYS NETWORKS HAS BEEN ADVISED OF, KNEW OF, OR SHOULD HAVE KNOWN OF, THE POSSIBILITY OF SUCH DAMAGES.

Enterasys Networks, Inc.

50 Minuteman Road

Andover, MA 01810

©2008 Enterasys Networks, Inc. All rights reserved. Part Number: 9034200 April 2008

ENTERASYS, ENTERASYS NETWORKS, ENTERASYS MATRIX, ENTERASYS NETSIGHT, LANVIEW, WEBVIEW, and any logos associated therewith, are trademarks or registered trademarks of Enterasys Networks, Inc., in the United States and other countries.

All other product names mentioned in this manual may be trademarks or registered trademarks of their respective companies.

Documentation URL: http://www.enterasys.com/support/manuals

Documentacion URL: http://www.enterasys.com/support/manuals

Dokumentation im Internet: http://www.enterasys.com/support/manuals

i

Image 3
Contents Enterasys Matrix X Router Page Page Regulatory Compliance Information Electromagnetic Compatibility EMC Supplement to Product Instructions Vcci Notice Declaration of Conformity Enterasys Networks, Inc. Firmware License Agreement Viii Page Page Contents Xii For information about Refer to Using This GuideUsing the Enterasys Matrix X Router Manual Set Who Should Use This GuideFollowing conventions are used in this guide Conventions Used in This GuideSupport@enterasys.com Getting HelpGetting Help Xvi About This Guide DC Power Supply Installation Overview of the DC Power Supply Circuit breakerEarth ground stud Back View of the DC Power Supply Power Supply Redundancy Planning Installation Site RequirementsVerify DC Power Compliance of Matrix X Modules Pre-Installation TasksWorksheet DC Compliance of Modules in Existing AC Systems Model Part No Part NumberDC Compliant? Model Part No Front Panel Serial Number DC Compliant? Worksheet DC Compliance of Modules for New DC SystemsModel Name Minimum 940 Part Number Minimum 940 Revision Minimum Revision of X Modules for DC PowerUnpacking the DC Power Supply Contents of X-DC Carton Installing the DC Power SupplyRemoving Power Supply Vent Plate Installing Power Supply Module Power supply slot Power supply coverplate Removing Blank Coverplate from Power Supply SlotRemoving a Power Supply Removing a Power Supply Removing a Power Supply DC Power Supply Installation Specification SpecificationsPhysical Specifications Electrical SpecificationsCompression Lugs Power Supply RedundancyModule Module Power SpecificationsRedundancy Configurations for DC Power Supply @ 48 VDCRegulatory Compliance Compliance StandardsRegulatory Compliance Standards