Enterasys Networks 3000 manual Mounting on the Ceiling

Page 28

Mounting the Access Point

Mounting on the Ceiling

To mount the Access Point 3000 on the ceiling, perform the following steps:

1.If you received washers with your kit, discard them.

2.Attach the mounting clips to the mounting bracket as shown below. Ensure that the screws line up with the holes on the tab of each side of the mounting bracket. Ensure that the nuts are secure, but do not tighten them.

3.Slide the mounting clips over the ceiling support, as shown below.

4.Tighten the bolts securely in place.

2-4 Hardware Installation

Image 28

Contents RoamAbout Page Page Europe European Union Notice Interference Statement FIN Approved Countries RBT3K-AG5150 5350-MHz 12400 -2483.5 MHz RBT3K-AG5150 5350 MHz 12400 2483.5 MHz Portugal Enterasys Networks, Inc Firmware License Agreement Page Page Xii Contents Figures About This Guide Purpose of This ManualIntended Audience Associated DocumentsGetting Help World Wide Web PhoneIntroduction Kit ChecklistOverview ‐1 displays the top view and back panel of the Access Point Hardware DescriptionComponent Description LED IndicatorsAntennas Reset Button Security SlotConsole Port Ethernet PortPower Connector Features and BenefitsApplications Applications Introduction Hardware Installation Preparing to Install Mounting the Access Point Mounting on a Horizontal SurfaceMounting on a Wall Mounting the Access Point Mounting on the Ceiling Removing the Access Point from the Mounting Bracket Connecting the Cables Lock Console POE Connecting the Cables Hardware Installation Using the CLI Initial ConfigurationRequired Connections Initial Configuration Using the CLI Disable DHCP. Type no ip dhcp Using the CLI Using Web Management Using Web Management Using Web Management Using Web Management Click the Management Vlan Enable radio button Login Specifications General SpecificationsNetwork Configuration Power SupplyWeight Modulation TypeTemperature Radio Signal CertificationNetwork Management HumiditySafety StandardsSensitivity 802.11a802.11g 802.11bTransmit Power Default Settings Feature Parameter DefaultVlan WEP Feature Parameter Default Cables and Pin-outs Twisted-Pair Cable AssignmentsStraight-Through Wiring 10/100BASE-TX Pin AssignmentsCrossover Wiring Console Port Pin AssignmentsRTS request to send CTS clear to send Unused Troubleshooting Troubleshooting StepsTroubleshooting Steps Maximum Distance Tables Maximum Distance Tables Troubleshooting