Enterasys Networks 3000 manual Using Web Management

Page 37

Using Web Management

Using Web Management

To use the Web interface to minimally configure the access point, perform the following steps:

1.Open a Web browser and enter the access point’s IP address in the address field:

–If your access point uses a DHCP assigned IP address, make sure the access point is connected to your network and enter the DHCP assigned IP address in your browser’s address field (use your DHCP server or other utility to determine the access point’s IP address).

–If your access point uses a static IP address, connect a system to the access point’s Ethernet port and enter the default IP address: http://192.168.1.1/ in your browser’s address field.

The access point’s Login window appears.

2.Enter the username admin and the password password and click LOGIN (for more information about the username and password, refer to Refer to the RoamAbout Access Point 3000 Configuration Guide for advanced configuration information.

.

The Country Code page appears.

RoamAbout Access Point 3000 Hardware Installation Guide 3-5

Image 37

Contents RoamAbout Page Page Europe European Union Notice Interference Statement FIN Approved Countries RBT3K-AG5150 5350-MHz 12400 -2483.5 MHz RBT3K-AG5150 5350 MHz 12400 2483.5 MHz Portugal Enterasys Networks, Inc Firmware License Agreement Page Page Xii Contents Figures Purpose of This Manual About This GuideIntended Audience Associated DocumentsWorld Wide Web Phone Getting HelpIntroduction Kit ChecklistOverview Hardware Description ‐1 displays the top view and back panel of the Access PointComponent Description LED IndicatorsAntennas Security Slot Reset ButtonConsole Port Ethernet PortPower Connector Features and BenefitsApplications Applications Introduction Preparing to Install Hardware InstallationMounting the Access Point Mounting on a Horizontal SurfaceMounting on a Wall Mounting the Access Point Mounting on the Ceiling Removing the Access Point from the Mounting Bracket Connecting the Cables Lock Console POE Connecting the Cables Hardware Installation Using the CLI Initial ConfigurationRequired Connections Initial Configuration Using the CLI Disable DHCP. Type no ip dhcp Using the CLI Using Web Management Using Web Management Using Web Management Using Web Management Click the Management Vlan Enable radio button Login General Specifications SpecificationsPower Supply Network ConfigurationWeight Modulation TypeRadio Signal Certification TemperatureNetwork Management HumidityStandards Safety802.11a Sensitivity802.11g 802.11bTransmit Power Feature Parameter Default Default SettingsVlan WEP Feature Parameter Default Twisted-Pair Cable Assignments Cables and Pin-outs10/100BASE-TX Pin Assignments Straight-Through WiringConsole Port Pin Assignments Crossover WiringRTS request to send CTS clear to send Unused Troubleshooting Steps TroubleshootingTroubleshooting Steps Maximum Distance Tables Maximum Distance Tables Troubleshooting