Enterasys Networks 3000 manual Removing the Access Point from the Mounting Bracket

Page 29

Removing the Access Point from the Mounting Bracket

5.Slide the access point over the mounting bracket to locate the three raised tabs. and lock them in place, as shown below.

Note: The access point will not slide if it was successfully locked into place.

6.Attach the locking clip to the mounting bracket and to the access point, as shown below.

5V/3A DC IN POE

LOCK

Removing the Access Point from the Mounting Bracket

To remove the access point from the mounting bracket:

1.Remove the locking clip, applicable.

2.Press down on the access point to compress the locking tabs.

3.Slide the access point off the mounting bracket.

RoamAbout Access Point 3000 Hardware Installation Guide 2-5

Image 29

Contents RoamAbout Page Page Europe European Union Notice Interference Statement FIN Approved Countries RBT3K-AG5150 5350-MHz 12400 -2483.5 MHz RBT3K-AG5150 5350 MHz 12400 2483.5 MHz Portugal Enterasys Networks, Inc Firmware License Agreement Page Page Xii Contents Figures Purpose of This Manual About This GuideIntended Audience Associated DocumentsWorld Wide Web Phone Getting HelpOverview Kit ChecklistIntroduction Hardware Description ‐1 displays the top view and back panel of the Access PointAntennas LED IndicatorsComponent Description Security Slot Reset ButtonConsole Port Ethernet PortApplications Features and BenefitsPower Connector Applications Introduction Preparing to Install Hardware InstallationMounting the Access Point Mounting on a Horizontal SurfaceMounting on a Wall Mounting the Access Point Mounting on the Ceiling Removing the Access Point from the Mounting Bracket Connecting the Cables Lock Console POE Connecting the Cables Hardware Installation Required Connections Initial ConfigurationUsing the CLI Initial Configuration Using the CLI Disable DHCP. Type no ip dhcp Using the CLI Using Web Management Using Web Management Using Web Management Using Web Management Click the Management Vlan Enable radio button Login General Specifications SpecificationsPower Supply Network ConfigurationWeight Modulation TypeRadio Signal Certification TemperatureNetwork Management HumidityStandards Safety802.11a Sensitivity802.11g 802.11bTransmit Power Feature Parameter Default Default SettingsVlan WEP Feature Parameter Default Twisted-Pair Cable Assignments Cables and Pin-outs10/100BASE-TX Pin Assignments Straight-Through WiringConsole Port Pin Assignments Crossover WiringRTS request to send CTS clear to send Unused Troubleshooting Steps TroubleshootingTroubleshooting Steps Maximum Distance Tables Maximum Distance Tables Troubleshooting