Enterasys Networks 3000 manual Using Web Management

Page 39

Using Web Management

The Administration page appears.

a.Click Reset, at the bottom of the page.

The access point prompts you to confirm that you want to reboot the system.

b.Click OK.

The access point reboots and the Login window appears.

5.Enter the username admin and the password password, and click LOGIN.

6.To set a static IP address, perform the following steps:

a.Click TCP/IP Settings from the menu on the left of the page. The TCP/IP Settings page appears.

RoamAbout Access Point 3000 Hardware Installation Guide 3-7

Image 39

Contents RoamAbout Page Page Europe European Union Notice Interference Statement FIN Approved Countries RBT3K-AG5150 5350-MHz 12400 -2483.5 MHz RBT3K-AG5150 5350 MHz 12400 2483.5 MHz Portugal Enterasys Networks, Inc Firmware License Agreement Page Page Xii Contents Figures Associated Documents About This GuidePurpose of This Manual Intended AudienceWorld Wide Web Phone Getting HelpKit Checklist IntroductionOverview Hardware Description ‐1 displays the top view and back panel of the Access PointLED Indicators Component DescriptionAntennas Ethernet Port Reset ButtonSecurity Slot Console PortFeatures and Benefits Power ConnectorApplications Applications Introduction Mounting on a Horizontal Surface Hardware InstallationPreparing to Install Mounting the Access PointMounting on a Wall Mounting the Access Point Mounting on the Ceiling Removing the Access Point from the Mounting Bracket Connecting the Cables Lock Console POE Connecting the Cables Hardware Installation Initial Configuration Using the CLIRequired Connections Initial Configuration Using the CLI Disable DHCP. Type no ip dhcp Using the CLI Using Web Management Using Web Management Using Web Management Using Web Management Click the Management Vlan Enable radio button Login General Specifications SpecificationsModulation Type Network ConfigurationPower Supply WeightHumidity TemperatureRadio Signal Certification Network ManagementStandards Safety802.11b Sensitivity802.11a 802.11gTransmit Power Feature Parameter Default Default SettingsVlan WEP Feature Parameter Default Twisted-Pair Cable Assignments Cables and Pin-outs10/100BASE-TX Pin Assignments Straight-Through WiringConsole Port Pin Assignments Crossover WiringRTS request to send CTS clear to send Unused Troubleshooting Steps TroubleshootingTroubleshooting Steps Maximum Distance Tables Maximum Distance Tables Troubleshooting