EnGenius Technologies ECB-1220R Appendix B IC Statement, IC Radiation Exposure Statement

Page 69

ECB-1220R 11b/g Wireless Client Bridge/AP/Router/Repeater

Version 1.1

Appendix B – IC Statement

IC statement

Operation is subject to the following two conditions: This device may not cause interference and

This device must accept any interference, including interference that may cause undesired operation of the device.

This device has been designed to operate with an antenna having a maximum gain of 9 dBi. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.

IMPORTANT NOTE:

IC Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Règlement d’Industry Canada

Les conditions de fonctionnement sont sujettes à deux conditions: Ce périphérique ne doit pas causer d’interférence et.

Ce périphérique doit accepter toute interférence, y compris les interférences pouvant perturber le bon fonctionnement de ce périphérique.

69

Image 69

Contents ECB-1220R Table of Contents Ireless S ITE S Urvey Revision History Introduction Features & BenefitsRouter/AP Mode Unit Description Package ContentsApplications System RequirementsWireless extensions to Ethernet networks Network ConfigurationWired LAN backup Ad-hoc peer-to-peer ModeInfrastructure Mode IP Address Configuration Hardware InstallationPage Access Point to Bridge/Bridge Router Bridge/Bridge Router to Access PointLogging Access Point/Router Mode Configƒ System ƒ Wireless ConfigurationManagement ƒ TCP/IP ConfigurationManagement Router mode Operation Mode Page Status Statistics Dynamic DNS Router mode Time Zone Setting Router mode Log Denial of Service DoS Router modeUpgrade Firmware Save / Reload Settings, Reset to Default TCP/IP Settings PasswordLAN Interface Snmp SettingsDhcp Client Wlan Interface Router modeRouter mode PPPoE Pptp Point-to-Point Tunneling Protocol Router mode Page Wireless Basic Settings Infrastructure, Adhoc Advanced Settings Security Encryption Disabled WEP 64-bit / 128-bit WPA / WPA2 Passphrase Wireless Distribution System WPA / WPA2 Radius AuthenticationFirewall Page Port Forwarding MAC Address FilterWeb site Filter DMZ Client Bridge/Router Mode Config Page System Operation Mode Status Statistics Upgrade Firmware Password TCP/IP Settings Dhcp Client Static IP AddressDhcp Server Snmp Settings Wlan Interface Client Bridge RouterPPPoE Page Basic Settings Advanced Settings Page Security WEP 64-bit / 128-bit WPA / WPA2 / WPA2 Mixed Passphrase Wireless Site Survey FCC Radiation Exposure Statement Federal Communication Commission Interference StatementIC Radiation Exposure Statement Appendix B IC Statement