EnGenius Technologies ECB-1220R user manual Basic Settings Infrastructure, Adhoc

Page 34

ECB-1220R 11b/g Wireless Client Bridge/AP/Router/Repeater

Version 1.1

Basic Settings (Infrastructure, Adhoc)

ƒClick on the Basic Settings link under the Wireless menu. Using this option you may configure the 802.11b/g settings as well as the frequency, channel, and SSID.

ƒ

ƒBand: Depending on the type of wireless clients that are connected to the network, you may select B, G, or B+G. If you are not sure about which clients will be accessing the wireless networks, it is recommended that you select B+G for the best performance.

ƒSSID: The SSID is a unique named shared amongst all the points of the wireless network. The SSID must be identical on all points of the wireless network and cannot exceed 32 characters.

ƒChannel: Select a channel from the drop-down list. The channels available are based on the country’s regulation. When selecting Infrastructure mode, a channel is not required, however, when selecting Adhoc mode, you must select the same channel on all points.

ƒEnable Universal Repeater Mode: Select Enable to activate Universal Repeater Mode and type below SSID for extended wireless interface.

34

Image 34
Contents ECB-1220R Table of Contents Ireless S ITE S Urvey Revision History Features & Benefits IntroductionRouter/AP Mode Package Contents Unit DescriptionSystem Requirements ApplicationsWired LAN backup Network ConfigurationWireless extensions to Ethernet networks Ad-hoc peer-to-peer ModeInfrastructure Mode Hardware Installation IP Address ConfigurationPage Bridge/Bridge Router to Access Point Access Point to Bridge/Bridge RouterAccess Point/Router Mode Config Loggingƒ Wireless Configuration ƒ Systemƒ TCP/IP Configuration ManagementManagement Router mode Operation Mode Page Status Statistics Dynamic DNS Router mode Time Zone Setting Router mode Denial of Service DoS Router mode LogUpgrade Firmware Save / Reload Settings, Reset to Default Password TCP/IP SettingsSnmp Settings LAN InterfaceWlan Interface Router mode Dhcp ClientRouter mode PPPoE Pptp Point-to-Point Tunneling Protocol Router mode Page Wireless Basic Settings Infrastructure, Adhoc Advanced Settings Security Encryption Disabled WEP 64-bit / 128-bit WPA / WPA2 Passphrase WPA / WPA2 Radius Authentication Wireless Distribution SystemFirewall Page MAC Address Filter Port ForwardingWeb site Filter DMZ Client Bridge/Router Mode Config Page System Operation Mode Status Statistics Upgrade Firmware Password TCP/IP Settings Static IP Address Dhcp ClientDhcp Server Snmp Settings Client Bridge Router Wlan InterfacePPPoE Page Basic Settings Advanced Settings Page Security WEP 64-bit / 128-bit WPA / WPA2 / WPA2 Mixed Passphrase Wireless Site Survey Federal Communication Commission Interference Statement FCC Radiation Exposure StatementAppendix B IC Statement IC Radiation Exposure Statement