EnGenius Technologies ECB3500 user manual Appendix B FCC Interference Statement

Page 116

Multi-Function Gigabit Wireless-N Client Bridge

Version 1.0

Appendix B – FCC Interference Statement

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

116

Image 116

Contents ECB3500 Table of Contents Cliet Bridge Operatig Mode Repeater Operatig Mode Federal Communication Commission Interference Statement Revision History Features & Benefits IntroductionPackage Contents Safety GuidelinesApplications Network ConfigurationSystem Requirements Ad-hoc peer-to-peer Mode 11b/g Wireless Long Range Multi-function 7+1 AP Version Understanding the Hardware Hardware InstallationIP Address Configuration 11b/g Wireless Long Range Multi-function 7+1 AP Version Switching Between Operating Modes 1Logging11b/g Wireless Long Range Multi-function 7+1 AP Version Access Point / WDS Operating Mode Access PointLogging StatusMain System Wireless Client ListSystem Log IP Settings System PropertiesSpanning Tree Settings Wireless Wireless NetworkWireless Security WEP 11b/g Wireless Long Range Multi-function 7+1 AP Version Wireless Security WPA-PSK, WPA2-PSK, WPA-Mixed Wireless Security WPA, WPA2Wireless MAC Filter WDS Link Settings Wireless Advanced SettingsAntenna Administration ManagementSnmp Settings Management VlanBackup/Restore settings, Reset to factory default settings Firmware Upgrade Time Settings 7 LogClient Bridge Operating Mode Status Connection Status System Log System Spanning Tree Settings Click on the Apply button to save the changes Prefer Bssid WDS Support Wireless Security WEP Wireless Security WPA-PSK, WPA2-PSK Management Administration Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log WDS Bridge Operating Mode Status WDS Link Status System IP Settings Spanning Tree Settings Wireless WDS Security WEP Wireless Advanced Settings Management Backup/Restore settings, Reset to factory default settings Firmware Upgrade Time Settings 11b/g Wireless Long Range Multi-function 7+1 AP Version Repeater Operating Mode Status Wireless Client List System Log System IP Settings Wireless Wireless Security WEP Wireless Security WPA-PSK, WPA2-PSK Wireless MAC Filter Management Administration Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log AP Router Operating Mode Status Dhcp Client List System Properties WAN Dhcp WAN SettingsRouter WAN Static IP 11b/g Wireless Long Range Multi-function 7+1 AP Version WAN PPPoE VPN Pass Through Wireless Security WEP Wireless Security WPA-PSK, WPA2-PSK Wireless MAC Filter WDS Link Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Time Settings 11b/g Wireless Long Range Multi-function 7+1 AP Version Client Router Operating Mode 2Status Connection Status System Log 100 101 102 103 104 105 Prefer Bssid 107 108 109 110 111 112 RF Spécifications Appendix a SpecificationsHardware Spécifications Software Features Environment & PhysicalPage Appendix B FCC Interference Statement Federal Communication Commission Interference StatementAppendix C IC Interference Statement Industry Canada statement