Parameter Default Description
BOOTP Get IP - IP is enabled but will not function until a BOOTP reply has been received. BOOTP requests will be periodically broadcast by the switch in an effort to learn its IP address. (BOOTP values can include the IP address, default gateway, and subnet mask.)
IP Connectivity Test (Ping)
Use the IP Connectivity Test to see if another site on the Internet can be reached. The screen shown below is described in the following table.
Vertical Horizon Local Management
Network Configuration: IP Connectivity Test (Ping)
IP Address : 200.123.211.109
Test Times : 1 | Interval : 3 |
Success : 0 | Failure : 0 |
[Start] |
|
<OK>
Use <TAB> or arrow keys to move, other keys to make changes.
| Figure |
|
|
Parameter | Description |
IP Address | IP address of the site you want to ping. |
Test Times | The number of ICMP echo requests to send to the specified site. |
| Range: 1~1000 |
Interval | The interval (in seconds) between pinging the specified site. |
| Range: 1~10 seconds |
Success/Failure | The number of times the specified site has responded or not to |
| pinging. |
|