Enterasys Networks VH-2402S manual Displays/configures extended bridge capabilities provided by

Page 18

Selection

Description

Device Control Menu

 

Port Configuration

Enables any port, enables/disables flow control, and sets

 

communication mode to auto-negotiation, full duplex or half

 

duplex.

Port Information

Displays operational status, including link state, flow control

 

method, and duplex mode.

Spanning Tree

Enables Spanning Tree Algorithm; also sets parameters for

Configuration

hello time, maximum message age, switch priority, and

 

forward delay; as well as port priority and path cost.

Spanning Tree

Displays full listing of parameters for the Spanning Tree

Information

Algorithm.

Mirror Port

Sets the source and target ports for mirroring.

Configuration

 

Port Trunking

Specifies ports to group into aggregate trunks.

Configuration

 

IGMP Configuration

Configures IGMP multicast filtering.

BStorm Control

Allows you to enable broadcast storm control and set the

Configuration

packet-per-second threshold.

Extented Bridge

Displays/configures extended bridge capabilities provided by

Configuration

this switch, including support for traffic classes, GMRP

 

multicast filtering, and VLAN extensions.

802.1P Configuration

Configures default port priorities and queue assignments.

802.1Q VLAN

Displays basic VLAN information, such as VLAN version

Base Information

number and maximum VLANs supported.

802.1Q VLAN Current

Displays VLAN groups and port members.

Table Information

 

802.1Q VLAN Static

Configures VLAN groups via static assignments, including

Table Configuration

setting port members, or restricting ports from being

 

dynamically added to a port by the GVRP protocol.

Port Assignment

Displays/configures port-specific VLAN settings, including

VLAN Configuration

PVID, ingress filtering, and 802.1Q trunks.

Multicast Router Port

Displays the ports on the switch attached to a neighboring

Information

multicast router/switch for each VLAN ID.

Static Multicast Router

Assigns ports that are attached to a neighboring multicast

Port Cfg

router/switch.

IGMP Member Port

Assigns ports that are attached to hosts who want to receive

Configuration

a specific multicast service.

Port Security

Allows you to enable and configure port security for the

Configuration

switch.

Network Monitor Menu

 

Port Statistics

Displays statistics on network traffic passing through the

 

selected port.

RMON Statistics

Displays detailed statistical information for the selected port

 

such as packet type and frame size counters.

Unicast Address Table

Provides full address listing, as well as search and clear

 

functions.

 

 

10 VH-2402S User Interface

VH-2402S

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Fast Ethernet Switch Management GuidePage 9033645-01 9033645-01 Table of Contents Snmp Management Appendix A. Spanning Tree ConceptsIndex Vi Table of Contents VH-2402S Required Connections Configuration OptionsManagement Overview Console Port Out-of-Band ConnectionsRemote Management via the Console Port Configure the Switch SiteConfigure the Remote Site In-Band ConnectionsIn-Band Network Connection Management Overview VH-2402S VH-2402S User Interface OverviewUser Access Factory Defaults Factory Default SettingsGvrp Main Menu Selection DescriptionDisplays/configures extended bridge capabilities provided by System Information Menu System Information MenuDisplaying System Information System InformationDisplaying Switch Version and Module Information Switch InformationManagement Setup Menu Management Setup MenuChanging the Network Configuration Network ConfigurationIP Configuration IP ConfigurationIP Connectivity Test Ping IP Connectivity TestHttp Configuration 10. Http ConfigurationConfiguring the Serial Port 11. Serial Port Configuration12. Snmp Configuration Assigning Snmp ParametersConfiguring Community Names 13. Snmp CommunitiesConfiguring IP Trap Managers 14. IP Trap ManagersConsole Login Configuration 15. Console Login ConfigurationUsing Tftp Protocol to Download Over the Network Downloading System SoftwareSaving the System Configuration Parameter DescriptionConfiguring Management Access 18. Management ConfigurationConfiguring the Switch 19. Device Control MenuNot implemented in the current firmware release Configuring Port Parameters 20. Port ConfigurationViewing the Current Port Configuration 21. Port InformationUsing the Spanning Tree Algorithm 22. Spanning Tree Configuration Configuring Bridge STADevice with the lowest MAC address will then Configuring STA for Ports or Modules 24. Spanning Tree Port ConfigurationViewing the Current Spanning Tree Configuration 25. Spanning Tree InformationDisplaying the Current Bridge STA 26. Bridge STA InformationDisplaying the Current STA for Ports or Modules 27. Spanning Tree Port InformationRules defining port status are Using a Mirror Port for Analysis 28. Mirror Port ConfigurationConfiguring Port Trunks 29. Port Trunking Configuration Igmp Multicast Filtering Configuring Igmp 30. Igmp ConfigurationConfiguring Broadcast Storm Control 31. Broadcast Storm Control ConfigurationConfiguring Bridge MIB Extensions 32. Extended Bridge ConfigurationBy setting this parameter to False Configuring Traffic Classes 33 .1P ConfigurationPort Priority Configuration 34 .1P Port Priority Configuration802.1P Port Traffic Class Information 35 .1P Port Traffic Class InformationConfiguring Virtual LANs 802.1Q Vlan Base Information802.1Q Vlan Current Table Information 37 .1Q Vlan Current Table Information802.1Q Vlan Static Table Configuration 38 .1Q Vlan Static Table Configuration39 .1Q Vlan Static Table Configuration Example Port Assignment Vlan Configuration 40. Port Assignment Vlan ConfigurationMulticast Router Port Information 41. Multicast Router Port InformationStatic Multicast Router Port Configuration 42. Static Multicast Router Port ConfigurationIgmp Member Port Configuration 43. Igmp Member Port ConfigurationPort Security Configuration 44. Port Security ConfigurationMonitoring the Switch 45. Network Monitor MenuDisplaying Port Statistics 46. Port StatisticsDisplaying Rmon Statistics 47. Rmon StatisticsDrop Events Displaying the Unicast Address Table 48. Unicast Address TableDisplaying the IP Multicast Registration Table 49. IP Multicast Registration TableConfiguring Static Unicast Addresses 50. Static Unicast Addreeess Table ConfigurationResetting the System Logging Off the System66 VH-2402S User Interface Configuring & Monitoring the Switch Common TasksSetting Password Protection Checking Network Configuration Status Connecting via TelnetAssigning an IP Address Setting Snmp Management Access Viewing Switch StatisticsConfiguring Port Mirroring Downloading a Software UpgradeDownloading Via the Serial Port Downloading Via Tftp9033645-01 Configuring Spanning Tree Parameters Configuring VLANs Configuring Class of ServiceConfiguring Port Operation Configuring the Unicast Address Table Setting a Default Gateway Configuring BootPConfiguring Port Trunks Configuring & Monitoring the Switch VH-2402S Snmp Management Snmp ProtocolMIB Objects RFC 1643 Ethernet-Like MIB RFC 1213 MIB-IIRFC 1573 Interfaces Evolution MIB RFC 1493 Bridge MIBCompiling MIB Extensions Enterasys Website Ieee 802.1Q Q-MIBEnterasys Proprietary MIB Extensions Spanning Tree Features Appendix A. Spanning Tree ConceptsGeneral Figure A-1. Spanning Tree Using VH-2402S Switches Spanning Tree Protocol in a NetworkTable A-1. Spanning Tree Protocol Defaults Spanning Tree Protocol ParametersSpanning Tree Protocol Operation 9033645-01 Spanning Tree Concepts VH-2402S Appendix B. Virtual Lans Vlans VLANs and Frame TaggingVlan Classification VH-2402S Vlan ConfigurationAssigning Ports to VLANs Port OverlappingForwarding Tagged/Untagged Frames Automatic Vlan RegistrationForwarding Traffic with Unknown Vlan Tags Appendix C. Class of Service Incoming tagged frames contain a priority level rangeFigure C-1. Class of Service Example Appendix D. IP Multicast Filtering Igmp Snooping and IP Multicast FilteringPage Index Tftp Page 150524-103 R02
Top Page Image Contents