Introduction
1.3.8 Restricting VLANs (802.1Q Mode)
This command will allow you to specify a list of VLAN IDs that should not be dynamically learned by GVRP. When the management processor receives a GVRP packet, it checks this database to determine if the learning of this ID should be restricted.
NOTE |
There is no support for GVRP with
For usage, refer to the VLAN Command in Chapter 2, Enhancements to LCM Commands.
1.3.9 Enable GVRP
GVRP can be enabled on a per port basis using the Port command.
NOTE |
There is no support for GVRP with
For further information, refer to the Port Command in Chapter 2, Enhancements to LCM Commands.