Dell B-FCX manual Hardware features Port status LEDs, Sfp+

1 Hardware features

TABLE 11	Port status LEDs (Continued)
LED		Condition	Status
SFP		On/Flashing Green	The SFP port has established a valid 100/1000 Mbps link.
(1F~4F)			Flashing indicates the port is transmitting and receiving user
Link or			packets.
Activity
		Off	A link is not established with a remote port.
SFP+		On/Flashing Green	The SFP+ port has established a valid 10 Gbps link. Flashing
(1F~4F)			indicates the port is transmitting and receiving user packets.
Link or
		Off	A link is not established with a remote port.
Activity

FIGURE 14 System status LEDs

1

Reset	1	2	Diag
Console	PS
Mgmt

1 System status LEDs

TABLE 12	System status LEDs
LED		Condition	Status
PS1		Green	Power supply is operating normally. It is installed properly and the
PS2			power cord is attached to a power source.
(Power Supply
		Amber	Power supply fault. The power supply may not be installed properly.
Status)
		Off	Power off or failure.
Diag		Flashing Green	System self-diagnostic test in progress.
(Diagnostic)
		Green	System self-diagnostic test successfully completed.
		Amber	System self-diagnostic test has detected a fault. (Blower, thermal or
			any interface fault.)
Out-of-band		On/Flashing Green	The port has established a valid link at 10/100/1000 Mbps.
Management			Flashing indicates the port is transmitting and receiving user
Link or Activity			packets.
		Off	A link is not established with a remote port.

12	PowerConnect B-FCX Switch Hardware Installation Guide
	53-1002267-01