3 Configuring IP addresses
FIGURE 34 Installing a transceiver in PowerConnect B-FCX624s and PowerConnect B-FCX648s devices
Slot 3 
A/S 
FIGURE 35 Installing a transceiver in PowerConnect B-FCX624 and PowerConnect B-FCX648
Cabling a fiber optic transceiver
Use the following steps to cable a fiber optic transceiver.
1.Remove the protective covering from the
2.Before cabling a fiber optic transceiver, Dell strongly recommends cleaning the cable connectors and the port connectors. For more information, refer to “Cleaning the fiber optic connectors” on page 43.
3.Gently insert the cable connector (a tab on each connector should face upward) into the transceiver connector until the tabs lock into place.
4.Observe the link and active LEDs to determine if the network connections are functioning
properly. For more information about the LED indicators, refer to Table 19.
42 | PowerConnect |
|