Carrier Access 3200 Interface Connectors, Front of Adit, Back of Adit, Grounding the Unit

Quick Start

Interface Connectors

Interface Connectors

The following are the Adit 3200 interface connectors:

Front of Adit

z(1) DS1 WAN port (RJ-48C). Note: E1 will be in a future release.

z(1) 10/100Base-T WAN port (RJ-45)

z(4) 10/100Base-T switched LAN ports (RJ-45)

Back of Adit

zRS-232 craft port connector for local management

zPower input connector

zGround connector

Grounding the Unit

WARNING! THE ADIT 3200 IS REQUIRED TO BE PERMANENTLY GROUNDED FOR THE PROTECTION OF USERS AND SERVICE PERSONNEL.

Chassis ground is located on the back of the unit. To ground the unit:

1.Connect a minimum 14 AWG ground wire with a #8 ring tongue terminal (not included) to the chassis ground on the back of the unit. Secure with the 8-32 screw and lock washer provided.

Chassis Ground

2.Connect the opposite end of the ground wire to a suitable earth grounding point such as a building grounding electrode, metal water pipe, or metal building

structure that is in compliance with article 250 of NEC.

12 Adit 3200 - Release 1.6