Carrier Access 3200 quick start Restore Factory Defaults, Select Restore Defaults

Page 23

Quick Start

Basic Configuration

Restore Factory Defaults

If the unit is not out-of-the-box, you may want to verify that the unit is set to defaults. Note: This will reset the IP address back to the default setting of 192.168.1.1.

In the web-browser:

zSelect Advanced from the Navigation bar

zSelect Restore Defaults

zSelect OK to restore defaults

Adit 3200 - Release 1.6

Image 23

Contents Adit Page Quick Start Guide Unpacking and Inspection Electrostatic Discharge ESD PrecautionsInstallation Environment Installation User SafetyCompliant Installation Wall Mounting To rack mount the Adit 3000, follow the instructions below Rack Mounting Optional FeatureTray Slide Adit 3104, 3200, 3300 and 3400 Battery Backup Back Chassis OverviewFront Grounding the Unit Interface ConnectorsFront of Adit Back of AditTo connect -48 VDC power PowerBattery Connection To connect AC powerDirection Description RS-232 Craft Port Female DB-9State Description DS1/E1 Connection PortsPin Name Description 10/100Base-TX Ethernet Reset ButtonAlarm/Status LEDs #show interface ethernet 2 Eth WAN To access the management consoleCommand Description Web-Based ManagementSet the New-line/Transmit value CR+LF Setting up a CLI ConnectionLog Adit 3200 show version Key Enabled Software FeaturesSetup Adit 3200 for access via Web-Browser Basic ConfigurationSelect Restore Defaults Restore Factory DefaultsModify Default Admin User Quick Start Web-browser Configure Ethernet WAN InterfaceSelect Apply to apply the new settings Set Network to WAN Configure Serial 1 as WAN