Carrier Access 3200 quick start Alarm/Status LEDs

Page 17

Quick Start

Alarm/Status LEDs

Alarm/Status LEDs

LED

State

Description

Critical

Off

No critical alarms present

 

 

 

 

Red

Critical alarms present. Critical alarms include:

 

 

user-configured manor environmental inputs.

 

 

 

Major

Off

No major alarms present

 

 

 

 

Red

Major alarm present. Major alarms include:

 

 

user-configured manor environmental inputs, DS1 short, DS1 open, DS1

 

 

facility alarm, DS1 RAI, DS1 AIS, DS1 LOF, DS1 LOS, WAN fault,

 

 

Ethernet fault and dead card alarms.

 

 

 

Minor

Off

No minor alarms present

 

 

 

 

Red

Minor alarms present. Minor alarms include:

 

 

user-configured minor environmental inputs, DS1 excessive line code

 

 

violations.

 

 

 

Status

Off

No power to system

 

 

 

 

Green

Application running, no detected system problems.

 

 

 

 

Green Flashing

Power-On Self Test (POST) successful. System booted. Loading

 

 

Application.

 

 

 

 

Green/Yellow

Flashing alternate colors. Application Self Test in Process.

 

 

 

 

Yellow

Yellow while booting. If this stays a steady yellow the Power-On Self Test

 

 

(POST) failed.

 

 

 

 

Yellow Flashing

Power-On Self Test (POST) In Process.

 

 

 

 

Red

System Failure

 

 

 

Adit 3200 - Release 1.6

17

Image 17 Contents
Adit Page Quick Start Guide Unpacking and Inspection Electrostatic Discharge ESD PrecautionsInstallation Environment Installation User SafetyCompliant Installation Wall Mounting To rack mount the Adit 3000, follow the instructions below Rack Mounting Optional FeatureTray Slide Adit 3104, 3200, 3300 and 3400 Battery Backup Back Chassis OverviewFront Front of Adit Interface ConnectorsBack of Adit Grounding the UnitBattery Connection PowerTo connect AC power To connect -48 VDC powerDirection Description RS-232 Craft Port Female DB-9State Description DS1/E1 Connection PortsPin Name Description 10/100Base-TX Ethernet Reset ButtonAlarm/Status LEDs Command Description To access the management consoleWeb-Based Management #show interface ethernet 2 Eth WANSet the New-line/Transmit value CR+LF Setting up a CLI ConnectionLog Adit 3200 show version Key Enabled Software FeaturesSetup Adit 3200 for access via Web-Browser Basic ConfigurationSelect Restore Defaults Restore Factory DefaultsModify Default Admin User Quick Start Web-browser Configure Ethernet WAN InterfaceSelect Apply to apply the new settings Set Network to WAN Configure Serial 1 as WAN
Related manuals
Manual 28 pages 57.46 Kb