Carrier Access 3200 quick start Select Apply to apply the new settings

Page 27

Quick Start

Basic Configuration

6.Set Internet Protocol to Obtain an IP Address Automatically, from the pulldown menu. This will enable the Adit 3200 as a DHCP Client. Leave the other fields to their default settings.

7. Select Apply to apply the new settings.

Adit 3200 - Release 1.6

Image 27

Contents

Adit Page Quick Start Guide Electrostatic Discharge ESD Precautions Installation EnvironmentUnpacking and Inspection Installation User SafetyCompliant Installation Wall Mounting To rack mount the Adit 3000, follow the instructions below Rack Mounting Optional FeatureTray Slide Adit 3104, 3200, 3300 and 3400 Battery Backup Chassis Overview FrontBack Grounding the Unit Interface ConnectorsFront of Adit Back of AditTo connect -48 VDC power PowerBattery Connection To connect AC powerDirection Description RS-232 Craft Port Female DB-9DS1/E1 Connection Ports Pin Name DescriptionState Description 10/100Base-TX Ethernet Reset ButtonAlarm/Status LEDs #show interface ethernet 2 Eth WAN To access the management consoleCommand Description Web-Based ManagementSet the New-line/Transmit value CR+LF Setting up a CLI ConnectionLog Adit 3200 show version Key Enabled Software FeaturesSetup Adit 3200 for access via Web-Browser Basic ConfigurationSelect Restore Defaults Restore Factory DefaultsModify Default Admin User Quick Start Web-browser Configure Ethernet WAN InterfaceSelect Apply to apply the new settings Set Network to WAN Configure Serial 1 as WAN

Related manuals

Manual 28 pages 57.46 Kb