Compliant Installation

Quick Start

Installation

NOTE: It is important the DS1/E1 Network Interface Cables are secured separately from the power and Signal Cables.

1.Inspect the unit.

2.Mount the unit, see Wall Mounting on page 7, or Rack Mounting (Optional Feature) on page 8 for detailed instructions.

3.Ground the unit. See Grounding the Unit on page 12.

WARNING! THE SEPARATE PROTECTIVE EARTHING TERMINAL PROVIDED ON THIS PRODUCT SHALL BE PERMANENTLY CONNECTED TO EARTH. SEE Grounding the Unit ON PAGE 12.

4.Connect DS1 (T1) and Ethernet connectors as needed.

5.Connect RS-232 connector and open Terminal Emulator software on your PC. Note: With this connected first, the boot process can be monitored.

6.Connect Power to the unit.

7.Monitor the boot process on your PC, when complete the status light should be green.

8.For any software enabled features, enter the key command. See the key command in the Adit 3000 CLI Reference Manual, for detailed information.

9.To verify use the show version command.

10.Now you can proceed to provisioning the unit. See Basic Configuration on page 22 for information.

6	Adit 3200 - Release 1.6