Carrier Access 3200 quick start Configure Ethernet WAN Interface, Web-browser

Page 26

Quick Start

Basic Configuration

Configure Ethernet WAN Interface

In the web-browser:

1.Select Network Connections from the Navigation bar.

2.It is recommended that you disable/delete the Serial1 port.

3.Select (click) Ethernet 2 (WAN Ethernet) connection to configure.

4.Select the Enable button, to configure the WAN Ethernet up (or in-service).

5.Select the Settings button.

26	Adit 3200 - Release 1.6

Image 26

Contents Adit Page Quick Start Guide Unpacking and Inspection Electrostatic Discharge ESD PrecautionsInstallation Environment User Safety InstallationCompliant Installation Wall Mounting Rack Mounting Optional Feature To rack mount the Adit 3000, follow the instructions belowTray Slide Adit 3104, 3200, 3300 and 3400 Battery Backup Back Chassis OverviewFront Back of Adit Interface ConnectorsFront of Adit Grounding the UnitTo connect AC power PowerBattery Connection To connect -48 VDC powerRS-232 Craft Port Female DB-9 Direction DescriptionState Description DS1/E1 Connection PortsPin Name Description Reset Button 10/100Base-TX EthernetAlarm/Status LEDs Web-Based Management To access the management consoleCommand Description #show interface ethernet 2 Eth WANSetting up a CLI Connection Set the New-line/Transmit value CR+LFLog Key Enabled Software Features Adit 3200 show versionBasic Configuration Setup Adit 3200 for access via Web-BrowserRestore Factory Defaults Select Restore DefaultsModify Default Admin User Quick Start Configure Ethernet WAN Interface Web-browserSelect Apply to apply the new settings Configure Serial 1 as WAN Set Network to WAN