Connect Tech BlueStorm Universal PCI, CTIM-00015 user manual Jumper Configuration for BlueStorm

BlueStorm Installation Guide, Connect Tech Inc.

Pin 1 Pin 1

6 x RJ-11

)Figure 6: BlueStorm/SP RJ-11 (8 Port Model)

Note: Refer to Table 8 for port 7 and port 8 pinouts.

Jumper Configuration for BlueStorm

Jumper configuration options will vary by model. BlueStorm/LP RS-422/485 cards feature the jumper layout listed in Figure 7, while BlueStorm/SP and BlueStorm/SP Opto cards use the jumper layout in Figure 8. Lastly, BlueStorm/SP RJ-11 uses the jumper layout used in Figure 9. BlueStorm ports and cards that communicate only in RS-232 modes do not have jumper blocks installed.

Figure 7 demonstrates a common set of jumper configurations for a BlueStorm/LP RS-422/485 card. BlueStorm/LP RS-232 ports do not require jumper configuration. The four RS-422/485 ports are set as follows: Port 1 is set for half duplex, Port 2 is set for half duplex, Port 3 is set for full duplex and Port 4 is set for multi-drop slave.

Figure 8 indicates a common set of jumper configurations for BlueStorm/SP and BlueStorm/SP Opto. The four ports are set as follows: Port 1 is set for RS-232, Port 2 is set for half duplex, Port 3 is set for full duplex and Port 4 is set for multi-drop slave.

Revision 0.10 11