Briggs & Stratton Power Products Automatic Transfer Switch
Installation and Owner’s Manual
Equipment Description | Mounting Dimensions |
These switches are a new generation of transfer switches that are intended to transfer the entire load of normal residential installations.The load is connected either to utility power (normal) or home standby power (emergency).The transfer switch monitors utility and generator voltages and will automatically connect to the appropriate source of power.
Major components of the transfer switch are a 2 pole double throw transfer switch, control circuit board, fused utility terminals and interconnecting wiring.
The transfer switch is
The control circuit board has active circuits sensing utility and generator voltages. It creates a signal for the generator
INSTALLATION
Unpacking
Delivery Inspection
After removing the carton, carefully inspect the transfer switch components for any damage that may have occurred during shipment.
IMPORTANT: If loss or damage is noted at time of delivery, have the person(s) making delivery note all damage on the freight bill and affix his signature under the consignor's memo of loss or damage. If loss or damage is noted after delivery, contact the carrier for claim procedures. Missing or damaged parts are not warranted.
Shipment Contents
•Automatic Power Transfer Switch
•Installation and Owner’s Manual
Figure 1 depicts the physical size and mounting hole locations of the NEMA 3R automatic transfer switch enclosure.This enclosure is suitable for indoor/outdoor use.
Figure 1 — Automatic Power Transfer Switch Dimensions
Enclosure Dimensions | Mounting Dimensions |
| Model 01813 |
Enclosure Dimensions | Mounting Dimensions |
| Model 01814 |
The transfer switch enclosure is commonly secured through the predrilled holes, as shown.
5