Advantech PCM-3601 user manual Error Correction & Data Compression, Voice/audio mode, Package

Page 4

-ITU-T G3 FAX Modulation

-CLASS 1 & CLASS 2 Command

-ITU-T T.30

- ITU-T V.17	14400 to 9600 bps
- ITU-T V.29	9600 to 4800 bps
- ITU-T V.27ter	4800 to 2400 bps
- ITU-T V.21 Channel2	300 bps

Error Correction & Data Compression

-MNP2 – 4 (ALT)

-MNP5 (ALT/CLASS5)

-V42 (LAPM)

-V42bis (BTLZ)

Voice/audio mode

-Voice transmit mode: PCM or ADPCM

-Enhanced ADPCM compression/decompression

-Tone detection/generation and call discrimination

-Concurrent DTMF detection

-8-bit monophonic audio data encoding at 11.025K HZ or 7.2K

HZ

NVRAM directory and stored profiles

- NVRAM SIZE:	256byte
- NO OF SCP:	2
- NO OF TEL SET:	4
- Length of each set:	31byte
- Total length:	124byte
Package
- R6764-61	100-Pin PQFP	(Rockwell)
- L2800	80-Pin PQFP	(Rockwell)
H/W SPEC.
- Freq.	: 28.224 MHz

	Page: 2

Image 4

Contents PCM-3601 Copyright notice Unpacking and Installation Feature Fdsp Full -duplex speakerphoneChapter Data modem throughput up to 115.2K bpsError Correction & Data Compression Voice/audio modeNvram directory and stored profiles PackageUnpacking the Modem Look at the Modem CardPC/104 FaxModem Card Installing the Modem Card Setting the COM Port and Interrupt of the Modem CardSerial Port and Interrupt of the Modem Card Testing the Telephone Line Prior to Connection Communications Software ConfigurationSoftware Configuration Tips AT&P0DP Getting StartedModem Basics Modem FundamentalsData Format Communications Protocol Speeds of the ModemOn-Line Speed DCE Speed Serial Port Speed DTE SpeedError-Correction and Data Compression Ecdc Flow Control Non-Volatile Memory NvramFactory Default Profile FDP Stored Configuration Profile SCPMajor Stored Configuration Profile Major SCP Active Configuration Area ACAStored Telephone Numbers STN Modem Operation and Response Codes Command State and Data StateEscape Sequence +++ Command Buffer Issuing CommandsDeleting Commands Modem AT Response Codes AT Commands Prefix, Repeat and Escape CommandsDial Commands and Dial Modifiers Operation CommandsW1 Enable V.42 response codes, display DCE speed M0 Set modem for async operation P0 M/B ratio 39/61USA Lease Line/Dial Line command set Option Call Back Security Command Set OptionLease Line Backup Dial Line command set Option Display Dialing Number if AT&In Command supportOption Auto Dial/Redial mode Option42bis and MNP Command Set Break ControlEcdc Operation Mode Selection MNP Response Code OptionData Compression Automatic RetrainModem Register Appendix aRegister Summary 1711h XON Character S33 255 Appendix B Result Codes+FCERROR Short Form Long Form Fax Class II Commands Fax Command Codes Fax ClassAppendix C +FDIS Installation of Modem Driver in Win 95/98 Appendix D