Advantech PCM-3601 user manual M0 Set modem for async operation P0 M/B ratio 39/61USA

Page 23

&K5 Unidirectional XON/OFF &K6 RTS/CTS, XON/XOFF flow

control

&M0 Set modem for async operation

&P0 M/B ratio 39/61(USA)

&P1 M/B ratio 33/67(UK, Hong Kong)

&P2 M/B ratio 39/61 at 20 pulses &P3 M/B ratio 33/67 at 20 pulses

&Q0 See & M0

&Q5 The modem will try to negotiate an error-corrected link

&Q6 Select asynchronous operation in normal mode

&R0 Modem turns CTS on when detects RTS from the local computer

&R1 Ignore RTS. Modem turns CTS on when ready to receive synchronously

&S0 Modem forces DSR always on

&S1 Set DSR to follow RS-232 spec

&T0 Terminates test in progress &T1 Initiates local analog

loopback, V.34 Loop3, Sets S16 bit0. If aconnect exists when this command is issued, the modem hangsup, The connect xxxx message is displayed upon the start of the test.

&T5 Disable digital loopback acknowledgment for remote request.

&T8 Initiates local analog loopback, V.34 Loop3, with selftest.

&V Display modem profiles and numbers

&W0 Write ACP to SCP0 &W1 Write ACP to SCP1

&Y0 Designate SCP0 as the

active SCP

&Y1 Designate SCP1 as the

active SCP

&Zn= Save up to three numbers to NVRAM. Use DS=n to dial the stored number

Note: &Q,&M: for Sync mode only

Page: 22

Image 23

Contents PCM-3601 Copyright notice Data modem throughput up to 115.2K bps Unpacking and InstallationFeature Fdsp Full -duplex speakerphone ChapterPackage Error Correction & Data CompressionVoice/audio mode Nvram directory and stored profilesLook at the Modem Card Unpacking the ModemPC/104 FaxModem Card Serial Port and Interrupt of the Modem Card Setting the COM Port and Interrupt of the Modem CardInstalling the Modem Card Communications Software Configuration Testing the Telephone Line Prior to ConnectionSoftware Configuration Tips Getting Started AT&P0DPData Format Modem FundamentalsModem Basics Speeds of the Modem Communications ProtocolSerial Port Speed DTE Speed On-Line Speed DCE SpeedError-Correction and Data Compression Ecdc Non-Volatile Memory Nvram Flow ControlActive Configuration Area ACA Factory Default Profile FDPStored Configuration Profile SCP Major Stored Configuration Profile Major SCPStored Telephone Numbers STN Escape Sequence +++ Command State and Data StateModem Operation and Response Codes Deleting Commands Issuing CommandsCommand Buffer Modem AT Response Codes Operation Commands AT CommandsPrefix, Repeat and Escape Commands Dial Commands and Dial ModifiersW1 Enable V.42 response codes, display DCE speed M0 Set modem for async operation P0 M/B ratio 39/61USA Lease Line Backup Dial Line command set Option Call Back Security Command Set OptionLease Line/Dial Line command set Option Auto Dial/Redial mode Option Display Dialing Number if AT&In Command supportOptionSet Break Control 42bis and MNP CommandAutomatic Retrain Ecdc Operation Mode SelectionMNP Response Code Option Data CompressionRegister Summary Appendix aModem Register 1711h XON Character S33 255 Result Codes Appendix B+FCERROR Short Form Long Form Appendix C Fax Command Codes Fax ClassFax Class II Commands +FDIS Appendix D Installation of Modem Driver in Win 95/98