Advantech PCM-3601 Ecdc Operation Mode Selection, MNP Response Code Option, Data Compression

Page 27

5.4 ECDC Operation Mode Selection

[\N]

\N0 Set modem to normal mode

\N1 Set modem to direct mode

\N2 Set modem to MNP reliable mode

\N3 Set to MNP/V.42 auto-eliable mode

\N4 V.42 reliable with phase detection

5.5 MNP Response Code Option

[\V]

\V0 Connect messages are controlled by the command settings X, W, and S95.

\V1 Connect message displayed in the single line format described below subject to the command settings V (Verbose) and Q(Quiet). In Non- Verbose mode(V0), single line connect messages are disabled and a single numeric result code is generated for CONNECT DTE.

5.6 Data Compression

[%C]

%C0 Disable data compression

%C1 Enable MNP5 data compression negotiation %C2 Enable V.42bis data compression

%C3 Enable both V.42bis and MNP5 data compression (default)

5.7 Automatic Retrain

[%E]

%E0 Disable auto-retrain %E1 Enable auto-retrain

%E2 Enable fallback/fall forward

Page: 26

Image 27

Contents PCM-3601 Copyright notice Data modem throughput up to 115.2K bps Unpacking and InstallationFeature Fdsp Full -duplex speakerphone ChapterPackage Error Correction & Data CompressionVoice/audio mode Nvram directory and stored profilesLook at the Modem Card Unpacking the ModemPC/104 FaxModem Card Setting the COM Port and Interrupt of the Modem Card Installing the Modem CardSerial Port and Interrupt of the Modem Card Communications Software Configuration Testing the Telephone Line Prior to ConnectionSoftware Configuration Tips Getting Started AT&P0DPModem Fundamentals Modem BasicsData Format Speeds of the Modem Communications ProtocolSerial Port Speed DTE Speed On-Line Speed DCE SpeedError-Correction and Data Compression Ecdc Non-Volatile Memory Nvram Flow ControlActive Configuration Area ACA Factory Default Profile FDPStored Configuration Profile SCP Major Stored Configuration Profile Major SCPStored Telephone Numbers STN Command State and Data State Modem Operation and Response CodesEscape Sequence +++ Issuing Commands Command BufferDeleting Commands Modem AT Response Codes Operation Commands AT CommandsPrefix, Repeat and Escape Commands Dial Commands and Dial ModifiersW1 Enable V.42 response codes, display DCE speed M0 Set modem for async operation P0 M/B ratio 39/61USA Call Back Security Command Set Option Lease Line/Dial Line command set OptionLease Line Backup Dial Line command set Option Auto Dial/Redial mode Option Display Dialing Number if AT&In Command supportOptionSet Break Control 42bis and MNP CommandAutomatic Retrain Ecdc Operation Mode SelectionMNP Response Code Option Data CompressionAppendix a Modem RegisterRegister Summary 1711h XON Character S33 255 Result Codes Appendix B+FCERROR Short Form Long Form Fax Command Codes Fax Class Fax Class II CommandsAppendix C +FDIS Appendix D Installation of Modem Driver in Win 95/98