Chapter 4 Management from a TerminalASM-60Installation and Operation Manual
Displaying the ASM-60 Status
| Main Menu | You can display the current status of the local and remote | |
|
|
| |
| ↓ 2 | To display the | |
| Display | • From the Display menu, type 1. | |
| ↓ 1 | ||
| Status | The Status screen is displayed (see Figure | |
|
| ||
|
|
|
|
|
|
|
|
| Status |
|
|
Device Rate: 6144 kbps
Remote Status: ASM60/SA CO
Active Software Version: 01.00
Hardware Version (PCB): 00
AFE Version: 00.00
DTE Interface Type: ETH_UTP
DCD Status: FAILED
Line A Lock Status: SYNC LOSS
Line B Lock Status: SYNC LOSS
Test Mode: NO TEST
Press any key to return to previous menu...
0.Sync Line A is COMPLETE
1.Sync Line B is COMPLETE
>
ESC - previous menu ; ! - main menu ; & - exit terminal
Figure 4-6. Status Screen
The Status screen provides the following information on
•Device rate – The current date rate of
•Device type –
•Active software version – Revision the software currently being used by
•Hardware version (PCB) – The H/W revision of the
•AFE version – The Analog Front End revision
•DTE interface type – The
•DCD status – Data Carrier Detect status, indicating if the line A, line B and the IMUX are synchronized
•Line A lock status – The synchronization status of the
•Line B lock status – The synchronization status of the
•Test mode – The current status of the diagnostic test (active or not active).
Displaying the |