RAD Data comm ASM-60 operation manual IR-IP DIP Switch, Table C-1. IR-IP LEDs Functions

ASM-60Installation and Operation Manual Appendix C IR-IP Interface Module

IR-IP LEDs

IR-IP contains three LEDs, which indicate the module activity. Table C-1lists the LEDs functions.

		Table C-1. IR-IP LEDs Functions
Name	Type	Function
INT	Green LED	ON – LAN integrity is established.
ACT	Yellow LED	Blinks – Transmit/receive activity is detected on the
		Ethernet link.
ERR	Red LED	ON – Buffer overflow occurred (during normal operation).
		During power-up, provides additional indications,
		described below.

IR-IP DIP Switch

IR-IP interface module contains a four-section DIP switch, as seen in Figure C-3.Table C-2lists the DIP switch functions.

Figure C-3. IR-IP DIP Switch

Table C-2. IR-IP DIP Switch Functions

No	Function	Values	Default Setting
1	Enables IR-IP to learn its IP	ON – IP address learning is enabled
		OFF – IP address learning is disabled	OFF
2	Selects the WAN protocol	ON – PPP protocol
		OFF – Frame Relay protocol	OFF
3	Selects the LAN mode	ON – Full duplex operation
		OFF – Half duplex operation	OFF
4	Controls the remote WAN test	ON – The test loopback is activated
	loopback, which returns packets	OFF – The test loopback is disabled	OFF
	received from the WAN back

toward the WAN

Table C-3provides the pinout of the IR-IP RJ-45 connector.

	Table C-3.	RJ-45 Pinout
Pin	Name	Function
1	TD (+)	Transmit data (positive)
2	TD (-)	Transmit data (negative)
3	RD (+)	Receive data (positive)
6	RD (-)	Receive data (negative)

Physical Description C-3