Chapter 4 Management from a TerminalASM-60Installation and Operation Manual
Table
Control Line | Interface Type | |
|
|
|
| DCE | DTE |
|
|
|
CTS | Out | Not Used |
|
|
|
DCD | Out | Out |
|
|
|
DSR | Out | Out |
|
|
|
DTR | In | In |
|
|
|
RI | Not Used | In |
|
|
|
RTS | In | In |
|
|
|
Data Terminal Ready (DTR)
When connected and turned on, the terminal sets the DTR line ON (active) to gain control over
Initiating a Control Session
To initiate a control session:
1.Connect the terminal cable to the CONTROL DCE connector of
2.Turn the control terminal on.
3.Configure the terminal to the default communication parameters: 19.2 kbps, one start bit, eight data bits, no parity, one stop bit, VT100.
4.Select the
5.Turn the terminal echo off
You are now ready to start a control session.
4.2 Navigating the Management Menus
This section provides a general description of the software menu operation and conventions for navigating the menus.
Figure 4-1 shows a map of the management menus in the ASM-60 embedded software.
To choose an option:
•Type the number corresponding to the option, and press <Enter>. The screen for the selected option is displayed.
To correct an erroneous entry:
•Press <Backspace> to clear the error, then enter the correct characters. or
Press <Esc> to exit the current menu, and then return to the menu to
Navigating the Management Menus |