RAD Data comm ASM-60 operation manual Interface Parameters Menu

ASM-60Installation and Operation Manual Appendix C IR-IP Interface Module

Device Name

Select this parameter to assign an arbitrary name to IR-IP for identification by the system manager (up to eight characters). The assigned name is displayed in the screen header.

Contact Person

Select this parameter to enter the name of the person to be contacted with matters pertaining to this equipment unit.

System Location

Select this parameter to enter the physical location of the device.

Interface Parameters Menu

The Interface Parameters menu is used to control the operation of IR-IP interfaces.

To access the Interface Parameters menu:

•From the Advanced Setup menu, type 2.

The Interface Parameters menu appears (Figure C-11).

IR_IP<IR-IP>S/W Ver. 1.00 31/IR (date)

Quick Setup Management Access Advanced Setup

.................................................................

Device identification Interface Parameters

=================================================================

1.	LAN Status	:[ Open	]
2.	WAN Status	:[ Open	]
3.	WAN Throttle	:[ Full	]
4.	Aging Timeout (min)	:5.

Press one of the numbers to select or ESC:

Figure C-11. Interface Parameters Menu

LAN Status

Used to enable/disable the flow of packets through LAN interface:

•Open – the flow of packets is enabled.

•Closed – the flow of packets is disabled. As a result, IR-IP does not accept, nor sends packets to the LAN, but its WAN interface may still be active, and can interact with other IP hosts on the WAN.

WAN Status

Used to enable/disable the flow of packets through the WAN interface:

•Open – the flow of packets is enabled.

•Closed – the flow of packets through the WAN interface is disabled. As a result, IR-IP does not accept from, nor sends packets to the WAN. However, the LAN interface of the IP router is still active.

Advanced Setup Menu C-15