CONNECTION USING COAXIAL CABLE:
Follow the instructions below to connect a VCR to your television using a 75 ohm coaxial cable. (CABLES NOT INCLUDED.)
VCR
INCOMING CATV CABLE
From VCR OUT jack |
| Side panel is accessible by pressing in on the | tabs, then |
|
|
| |
|
| ||
| lift the side cover off. After connections have been | ||
| made, slide the wires through the bottom opening of the | ||
| cover and replace cover. | ||
1.Connect the cable, satellite
or incoming antenna to the VHF/UHF IN jack on the rear of the VCR.
2.Connect a 75 ohm coaxial cable from the VCR’s 75 Ohm OUT jack to the Antenna IN jack on the side of the TV.
3.Press the SOURCE button until “TV” appears on the TV screen and press PLAY on the VCR to watch a tape.
CONNECTION USING AUDIO/VIDEO CABLES:
Follow the instructions below to connect a VCR to your television using Audio/Video cables. (CABLES NOT INCLUDED.)
Jack panel is shown on its side. Top of panel is this side.
1.Connect the cable, satellite or incoming antenna to the VHF/UHF IN jack on the rear of the VCR.
2.Connect the left and right audio cable from the VCR’s AUDIO OUT jacks to the TV’s left and right AUDIO IN jacks. Connect the VCR’s VIDEO OUT jack to the TV’s VIDEO IN jack.
3.Press the SOURCE button until AV appears on the TV screen and press PLAY on the VCR to watch a tape.
NOTE: Side panel is accessible by pressing in on the tabs, then lift the side cover off. After connections have been made, slide the wires through the bottom opening of the cover and replace cover.
FAQ:
My VCR has only 1 Audio jack, but this TV has two Audio input jacks, how do I connect it? Simply connect it to the “L (Mono)” Audio input jack, but the sound will be monaural.
10