Memorex MLT1912 manual Connection Using Component Cables

CONNECTION USING S-VIDEO CABLE:

Follow the instructions below to connect a DVD player to your television using the S-Video cable. (CABLES NOT INCLUDED.)

			1. Connect the left and right audio cable from
			the DVD’s AUDIO OUT jacks to the TV’s
			left and right AUDIO IN jacks.
			2. Connect the DVD’s S-VIDEO OUT jack to
			the TV’s S-VIDEO IN jack.
			3. Press the SOURCE button until S-VIDEO
			appears on the TV screen and press PLAY
			on the DVD to watch the DVD.
			NOTE: Side panel is accessible by pressing in
			on the tabs, then lift the side cover off. After
			connections have been made, slide the wires
Jack	panel	is	through the bottom opening of the cover and
			replace cover.
shown on its side.
Top	of panel	is
this side.

CONNECTION USING COMPONENT CABLES:

Follow the instructions below to connect a DVD player to your television using the Y, Pb, Pr jacks.

(CABLES NOT INCLUDED.)

1. Connect the left and right audio cable from the DVD’s AUDIO OUT jacks to the TV’s audio left and right COMPONENT IN jacks.

2. Connect the component cables (not included) from the DVD's Y, Pb/Cb, Pr/Cr OUT jacks to the TV’s Component IN (Y, Pb, Pr) jacks.

3. Press the SOURCE button until YUV appears on the TV screen and press PLAY on the DVD to watch a DVD.

NOTE: Connecting the DVD player to the TV using the component cables will provide the highest quality picture. Connecting using an

S-video cable will provide the next highest

quality picture, followed by standard Audio/

Video cable connection.

12