Memorex MLT1912 manual Installing the Stand

Follow the instructions below to connect a computer to your television/monitor. (CABLES NOT INCLUDED.)

Jack Panel is shown on its side. Top of panel is this side.

1. Turn off the TV and your computer (PC).

2. Connect the audio cable (not included) from the computer’s AUDIO OUT jack to the TV’s VGA AUDIO IN jack.

3. Connect a VGA cable from the computer’s VGA OUT jack to the TV’s VGA IN jack.

4. Turn on the TV and press the SOURCE button until PC appears on the TV screen.

5. Turn on your computer and the computer screen will appear.

NOTES:

• You must follow the above steps when you connect between the computer and the television for the first time; otherwise, the computer screen may not appear.

• Refer to the computer’s owner’s manual for additional instructions.

• Side panel is accessible by pressing in on the tabs, then lift the side cover off. After connections have been made, slide the wires through the bottom opening of the cover and replace cover.

INSTALLING THE STAND

	Gently insert the bottom
	leg (A) into the stand (B)
	until the tabs (C) click
	into place.
	(A)
(C)	(C)
(C)	(C)
(C)	(C)
	(B)
	13