National Instruments FP-1600, network module quick start Configure I/O Modules

Page 14

10 Configure I/O Modules

A. Right-click on the device name in FieldPoint Explorer and select Edit this Device from the pop-up menu.

B. Click on the Channel Configuration button to bring up the Channel Configuration dialog box.

C. Select the type of channel to show, then select the channel(s) that you want to change. To select more than one channel, uncheck the One channel at a time box.

NOTE: Configuration options are module-dependent. The options listed here might not be available for your particular module. Refer to your I/O module operating instructions for details on configuration options.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents What You Need to Get Set Up Install the Network ModuleLock rail clip Install the Terminal Bases Place protective cover on last base Install the I/O Modules Connect the Network CablesWire Power to Your FieldPoint System FP-1600 FP-AI-100 FP-AO-200 Connect to Field Devices FP-AI-110Power Up Your FieldPoint System Install the FieldPoint Software Verify the InstallationEthernet as the Type IP address is the address of the FP-1600 on the network Click on Find DevicesSelect File»Save Configure I/O Modules Select File»Save when you are done Where to Go from Here FP-1600 Specifications 11 to 30 VDCMechanical Dimensions Copyright 1999, 2000 National Instruments Corporation
Top Page Image Contents