National Instruments network module, FP-1600 quick start Select File»Save when you are done

Page 15

D. Set the range and output values of the selected channel(s).

E.Set the attributes for the selected channel(s) by selecting the attribute and entering the desired value.

F.Send commands to the selected channel(s) by choosing a command and value and clicking on Send.

G.Repeat this procedure for each channel you want to configure.

H.Click on the OK button when you are finished, or click on the Apply button to save the changes and continue to configure channels. When you click on OK or Apply, the changes are immediately sent to the device.

I.Select File»Save when you are done.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Install the Network Module What You Need to Get Set UpLock rail clip Install the Terminal Bases Place protective cover on last base Connect the Network Cables Install the I/O ModulesWire Power to Your FieldPoint System FP-1600 FP-AI-100 FP-AO-200 FP-AI-110 Connect to Field DevicesPower Up Your FieldPoint System Verify the Installation Install the FieldPoint SoftwareEthernet as the Type Click on Find Devices IP address is the address of the FP-1600 on the networkSelect File»Save Configure I/O Modules Select File»Save when you are done Where to Go from Here 11 to 30 VDC FP-1600 SpecificationsMechanical Dimensions Copyright 1999, 2000 National Instruments Corporation
Top Page Image Contents