National Instruments network module, FP-1600 quick start Select File»Save

Page 13

If your modules are not listed, check the cable and connections and make sure the modules are all powered on. If you still have problems, refer to your FP-1600 user manual for troubleshooting information.

I.Select an input module and

click on the start monitoring button to view live data.

J.Select an output channel and click on the write button to change outputs.

K.Select File»Save.

13

Image 13

Contents Install the Network Module What You Need to Get Set UpLock rail clip Install the Terminal Bases Place protective cover on last base Connect the Network Cables Install the I/O ModulesWire Power to Your FieldPoint System FP-1600 FP-AI-100 FP-AO-200 FP-AI-110 Connect to Field DevicesPower Up Your FieldPoint System Verify the Installation Install the FieldPoint SoftwareEthernet as the Type Click on Find Devices IP address is the address of the FP-1600 on the networkSelect File»Save Configure I/O Modules Select File»Save when you are done Where to Go from Here 11 to 30 VDC FP-1600 SpecificationsMechanical Dimensions Copyright 1999, 2000 National Instruments Corporation