National Instruments network module, FP-1600 quick start What You Need to Get Set Up

Page 1

FP-1600 FieldPoint Quick Start Guide

What You Need to Get Set Up

·	Network Module	·	Power Supply
·	Mounting Hardware (DIN rail	·	FieldPoint Software CD
	or panel mount accessory)	·	Accessories: Ethernet cable,
·	Terminal Base(s)		screwdriver

·I/O Module(s)

1 Install the Network Module

DIN Rail Mount

A. Unlock rail clip.

Panel Mount

A. Unlock rail clip.

1

Image 1

Contents Install the Network Module What You Need to Get Set UpLock rail clip Install the Terminal Bases Place protective cover on last base Connect the Network Cables Install the I/O ModulesWire Power to Your FieldPoint System FP-1600 FP-AI-100 FP-AO-200 FP-AI-110 Connect to Field DevicesPower Up Your FieldPoint System Verify the Installation Install the FieldPoint SoftwareEthernet as the Type Click on Find Devices IP address is the address of the FP-1600 on the networkSelect File»Save Configure I/O Modules Select File»Save when you are done Where to Go from Here 11 to 30 VDC FP-1600 SpecificationsMechanical Dimensions Copyright 1999, 2000 National Instruments Corporation