National Instruments network module quick start FP-1600 FP-AI-100 FP-AO-200

Page 7

CAUTION: Cascading power from neighboring bases or network modules defeats isolation between cascaded modules.

	Separate Power Supply
	(Recommended)
	Cascaded Power			No External
	Cascaded Power		Power Required
	(Reduces Isolation)
FP-1600	FP-AI-100	FP-AO-200	FP-RLY-420	FP-TC-120

Power Supply

Power Supply

Shades of gray indicate different voltage potentials.

15 16 V	V 1 2 3
31 32 C	C 17

CAUTION: Cascading power defeats isolation.

7

Image 7

Contents Install the Network Module What You Need to Get Set UpLock rail clip Install the Terminal Bases Place protective cover on last base Connect the Network Cables Install the I/O ModulesWire Power to Your FieldPoint System FP-1600 FP-AI-100 FP-AO-200 FP-AI-110 Connect to Field DevicesPower Up Your FieldPoint System Verify the Installation Install the FieldPoint SoftwareEthernet as the Type Click on Find Devices IP address is the address of the FP-1600 on the networkSelect File»Save Configure I/O Modules Select File»Save when you are done Where to Go from Here 11 to 30 VDC FP-1600 SpecificationsMechanical Dimensions Copyright 1999, 2000 National Instruments Corporation