National Instruments network module IP address is the address of the FP-1600 on the network

Page 12

E.In the FP-1600 Properties box, enter values for the IP address, Subnet mask, and Time server IP. You might also want to enter a comment to help you identify the FP-1600 module.

• IP address is the address of the FP-1600 on the network.

•Subnet mask is the mask that is applied to the IP address that the device uses to find other devices on the Ethernet network (255.255.255.0 is the most common).

•Time server IP is the address of the

host computer that the FP-1600 will synchronize its clock to. The computer must have the Lookout Time Synch service (installed with Lookout 4.x or FieldPoint 2.x).

FClick on Apply, then OK twice to return to the Comm Resource Configuration dialog box.

G.Click on Find Devices.

H.Expand the +FP Res item on the left side of the Explorer window to see the devices found on the network.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents What You Need to Get Set Up Install the Network ModuleLock rail clip Install the Terminal Bases Place protective cover on last base Install the I/O Modules Connect the Network CablesWire Power to Your FieldPoint System FP-1600 FP-AI-100 FP-AO-200 Connect to Field Devices FP-AI-110Power Up Your FieldPoint System Install the FieldPoint Software Verify the InstallationEthernet as the Type IP address is the address of the FP-1600 on the network Click on Find DevicesSelect File»Save Configure I/O Modules Select File»Save when you are done Where to Go from Here FP-1600 Specifications 11 to 30 VDCMechanical Dimensions Copyright 1999, 2000 National Instruments Corporation
Top Page Image Contents